Skip to main content
main-content

Tipp

Weitere Artikel dieser Ausgabe durch Wischen aufrufen

20.07.2018 | Original | Ausgabe 5/2018 Open Access

European Journal of Wood and Wood Products 5/2018

Cold tack of urea formaldehyde resins as an important factor in plywood production

Zeitschrift:
European Journal of Wood and Wood Products > Ausgabe 5/2018
Autoren:
Elfriede M. Hogger, Hendrikus W. G. van Herwijnen, Johann Moser, Wolfgang Kantner, Johannes Konnerth
Wichtige Hinweise

Publisher’s Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Abstract

The ability of urea formaldehyde (UF) resins to develop cold tack is needed in plywood production during pre-pressing in a cold press to ensure that the veneers stick together, can be transported, and fit into a multi-daylight hot press. The influence of defined factors on the cold tack was analyzed by determining the tensile shear strength of uncured birch veneers bonded with UF resin, and the statistically significant impact factors were determined. The factors tested were lay-up time, resin amount, resin age, moisture content, veneer temperature and pre-press time. Moisture content and veneer temperature had the highest impact on the cold tack of UF resins. A negative impact of high moisture content on the tensile shear strength and therefore on the cold tack of UF resins was proven as well as a positive impact of a comparably high (30 °C) veneer temperature. Lay-up time and pre-press time showed a minor impact on the tensile shear strength. Models were created using Design-Expert software to calculate the optimum operation conditions for cold tack.
Literatur
Über diesen Artikel

Weitere Artikel der Ausgabe 5/2018

European Journal of Wood and Wood Products 5/2018 Zur Ausgabe