Effect of cutting tool blunting on the performances of various mechanical excavators used in low- and medium-strength rocks

Full-scale laboratory cutting tests that measure the specific energy (SE) are widely used to evaluate rock cuttability by mechanical excavators, and in particular roadheaders fitted with radial or drag-type bits. Radial or drag-type bits are often changed during operation as they wear and become blunt. In this study, full-scale cutting tests were carried out on different rock types using bits with varying degrees of wear in order to assess the impacts of pick bluntness on cutting forces and the SE. The relationships between wear flats and cutting forces, SE, and various rock properties such as uniaxial compressive strength, tensile strength, indentation index, Shore hardness, Schmidt hammer hardness, and density were examined and are discussed in this paper. The mean cutting force increased 2- to 3-fold and the cutting SE rose 4- to 5-fold with a 4-mm wear flat as compared to a sharp pick. Critical wear flats were plotted for different rock property values, and 25 MJ/m³ was considered the threshold SE above which cutting performance was considered to be poor. Best-fit predictive models based on statistical analysis of the laboratory cutting test results are introduced as a means to estimate SE as a function of bit type, wear condition, and various mechanical properties of the rock. These models can be used to predict the performances of mechanical excavators that use radial tools, especially roadheaders, continuous miners, and longwall drum shearers.