Top

Archive of Applied Mechanics

Published in:

31-10-2020 | Technical Note

Early warning analysis of online vibration fault characteristics of motor base screw loosening based on similarity measurement theory

Authors: Feng Zhou, Pengcheng Xu, Kun Lin

Published in: Archive of Applied Mechanics | Issue 4/2021

Activate our intelligent search to find suitable subject content or patents.

search-config

AI-assisted search

Off

Abstract

When small- and medium-sized motors are running, abnormal vibration phenomenon caused by various reasons often occur, and continuous development may cause serious motor failure. Therefore, online monitoring and warning for motor vibration is very important. Among them, the looseness of the base fixing screw is the most common and typical cause of abnormal vibration of the motor. Based on the similarity measurement theory, a new method for predicting the fault characteristics of the motor base screw loosening online vibration is proposed in this paper. Firstly, the causes of motor vibration signals are analyzed, and the vibration characteristics of different causes are classified. The vibration fault characteristics of the pedestal fixing screws are mainly studied. The vibration signal generated by the looseness of the base fixing screw is collected by the designed real-time online vibration monitoring system. Then, a fast Fourier transform of the vibration signal is carried out to obtain the corresponding amplitude and frequency characteristic curve. By using the two schemes of ‘Cosine similarity and modulus ratio combination’ and ‘Correlation coefficient combined with vector norm,’ the vibration fault characteristics are analyzed and compared, the vibration fault characteristic signal is extracted, and the vibration reason is determined and alerted by combining fault characteristic classification. Finally, this method is used to compare and test the working condition of the motor frame fixing screw loosening and the normal operation of the motor. The experimental results show that the algorithm which combines correlation coefficient with 1-norm has the advantages of simple algorithm and high accuracy. The method also provides new solutions and ideas for online warning of abnormal vibration caused by other reasons.

next article The novel design concept for the tensioning system of an inflatable planar membrane reflector

Dont have a licence yet? Then find out more about our products and how to get one now:

Springer Professional "Wirtschaft+Technik"

Online-Abonnement

Mit Springer Professional "Wirtschaft+Technik" erhalten Sie Zugriff auf:

über 102.000 Bücher
über 537 Zeitschriften

aus folgenden Fachgebieten:

Automobil + Motoren
Bauwesen + Immobilien
Business IT + Informatik
Elektrotechnik + Elektronik
Energie + Nachhaltigkeit
Finance + Banking
Management + Führung
Marketing + Vertrieb
Maschinenbau + Werkstoffe
Versicherung + Risiko

Jetzt Wissensvorsprung sichern!

inform now

Springer Professional "Technik"

Online-Abonnement

Mit Springer Professional "Technik" erhalten Sie Zugriff auf:

über 67.000 Bücher
über 390 Zeitschriften

aus folgenden Fachgebieten:

Automobil + Motoren
Bauwesen + Immobilien
Business IT + Informatik
Elektrotechnik + Elektronik
Energie + Nachhaltigkeit
Maschinenbau + Werkstoffe

Jetzt Wissensvorsprung sichern!

inform now

Chang, H.-C., Jheng, Y.-M., Kuo, C.-C., Huang, L.-B.: On-line motor condition monitoring system for abnormality detection. Comput. Electr. Eng. 51, 255–269 (2016)CrossRef

Irfan, M., Saad, N., Ibrahim, R., Asirvadam, V.S.: Condition monitoring of induction motors via instantaneous power analysis. J. Intell. Manuf. 28(6), 1259–1267 (2017)CrossRef

Khatami Rad, M., Torabizadeh, M., Noshadi, A.: Artificial Neural Network-based fault diagnostics of an electric motor using vibration monitoring, in Proceedings 2011 International Conference on Transportation, Mechanical, and Electrical Engineering (TMEE), Changchun, 1512–1516 (2011). https://doi.org/10.1109/TMEE.2011.6199495

Schoen, R.R., Lin, B.K., Habetler, T.G., Schlag, J.H., Farag, S.: An unsupervised, on-line system for induction motor fault detection using stator current monitoring. IEEE Trans. Ind. Appl. 31(6), 1280–1286 (1994)CrossRef

Rahimilarki, R., Gao, Z.: Grey-box model identification and fault detection of wind turbines using artificial neural networks, 2018 IEEE 16th International Conference on Industrial Informatics (INDIN), Porto, 647–652, (2018) https://doi.org/10.1109/INDIN.2018.8471943

Kumar, G., Sharma, S., Malik, H.: Learning vector quantization neural network based external fault diagnosis model for three phase induction motor using current signature analysis, in Procedia Computer Science 2016, vol. 93, pp. 1010–1016 (2016). https://doi.org/10.1016/j.procs.2016.07.304

Dwi, P.A., Alfaradin, F., Darojah, Z., Sanggar, D.R.: Artificial Neural Network based identification system for abnormal vibration of motor rotating disc system. IES Surabaya 2015, 251–256 (2015). https://doi.org/10.1109/ELECSYM.2015.7380850CrossRef

Patel, R.K., Giri, V.K.: ANN based performance evaluation of BDI for condition monitoring of induction motor bearings. J. Inst. Eng. India Ser. B 98, 267–274 (2017). https://doi.org/10.1007/s40031-016-0251-7CrossRef

Kolla, S.R., Altman, S.D.: Artificial neural network based fault identification scheme implementation for a three-phase induction motor. ISA Trans. 46(2), 261–266 (2007)CrossRef

10.

Debray, K., Bogard, F., Guo, Y.Q.: Numerical vibration analysis on defect detection in revolving machines using two bearing models. Arch. Appl. Mech. 74, 45–58 (2004)CrossRef

11.

Janier, J.B., Zaharia, M.F.Z.: Condition monitoring system for induction motor using fuzzy logic tool, in 2011 First International Conference on Informatics and Computational Intelligence, Bandung, pp. 3–7. (2011) https://doi.org/10.1109/ICI.2011.11

12.

Ibrahim, S.O., Faris, K.N., Elzahab, E.A.: Implementation of fuzzy modeling system for faults detection and diagnosis in three phase induction motor drive system. J. Electr. Syst. Inf. Technol. 2(1), 27–46 (2015)CrossRef

13.

Jiang, J., Chang, H., Kuo, C.: Operating monitoring and fault types classification for motors through vibration signal, in 2016 International Symposium on Computer, Consumer and Control (IS3C), Xi’an, pp. 61–64. (2016) https://doi.org/10.1109/IS3C.2016.26

14.

Shrivastava, A., Wadhwani, S.: An approach for fault detection and diagnosis of rotating electrical machine using vibration signal analysis, in International conference on recent advances and innovations in engineering (ICRAIE-2014), Jaipur, pp. 1–6. (2014) https://doi.org/10.1109/ICRAIE.2014.6909160

15.

Wang, C., Liu, Y., Guo, L., Yue, Y., Maple, C.: An on-line distributed induction motor monitoring system based-on ARM and CAN bus, in 2011 Sixth International Symposium on Parallel Computing in Electrical Engineering, Luton, pp. 185–188 (2011). https://doi.org/10.1109/PARELEC.2011.16

16.

Jin, H.: The servo motor status monitor system of measure and control antenna based on network model, in 2014 IEEE Workshop on Advanced Research and Technology in Industry Applications (WARTIA), Ottawa, ON, pp. 1408–1410 (2014). https://doi.org/10.1109/WARTIA.2014.6976547

17.

Fulzele, A.G., Arajpure, V.G., Holay, P.P., et al.: Condition monitoring of shaft of single-phase induction motor using optical sensor. Mech. Syst. Signal Process. 29(May), 428–435 (2012). https://doi.org/10.1016/j.ymssp.2011.12.002CrossRef

18.

Caldero, P., Zoeke, D.: Multi-channel real-time condition monitoring system based on wideband vibration analysis of motor shafts using SAW RFID tags coupled with sensors. Sensors 19(24), 5398 (2019). https://doi.org/10.3390/s19245398CrossRef

19.

Fanjun, L., Binggang, C., Junping, W., Kai, Z.: Color image similarity measurement and its application in matching, in 2009 Second International Conference on Intelligent Computation Technology and Automation, Changsha, Hunan, pp. 566–568 (2009) https://doi.org/10.1109/ICICTA.2009.143

20.

Xiao, Z.: A Multi-scale Structure SIMilarity metric for image fusion qulity assessment, in 2011 International Conference on Wavelet Analysis and Pattern Recognition, Guilin, pp. 69–72 (2011) https://doi.org/10.1109/ICWAPR.2011.6014491

Title: Early warning analysis of online vibration fault characteristics of motor base screw loosening based on similarity measurement theory
Authors: Feng Zhou
Pengcheng Xu
Kun Lin
Publication date: 31-10-2020
Publisher: Springer Berlin Heidelberg
Published in: Archive of Applied Mechanics / Issue 4/2021
Print ISSN: 0939-1533
Electronic ISSN: 1432-0681
DOI: https://doi.org/10.1007/s00419-020-01820-1

Springer Professional

Abstract

Please log in to get access to your license.

Dont have a licence yet? Then find out more about our products and how to get one now:

Springer Professional "Wirtschaft+Technik"

Springer Professional "Technik"

Other articles of this Issue 4/2021

Applications of adaptive stiffness suspensions to vibration control of a high-speed stiff rotor with tilting pad bearings

Analysis of static stiffness fluctuation in radially loaded ball and roller bearings

An optimal parameter identification approach in foil bearing supported high-speed turbocharger rotor system

Experimental assessment of temperature effect on open-hole notch sensitivity in woven carbon fiber composites

Elastic–plastic problem for a circular hole plate with regard to crack initiation in elastic zone

Analytical investigation of elastic and plastic behavior of rotating double-walled FGM-homogenous hollow shafts

Premium Partners