Effect of cooling rate on the crystal/mesophase polymorphism of polyamide 6

The solidification of the quiescent polyamide 6 (PA 6) melt has been analyzed as a function of the cooling rate in a wide range between 1.67 × 10⁻² and close to 2 × 10² K s⁻¹, by means of differential scanning calorimetry at a low cooling rate of up to about 1 K s⁻¹, and by the recording of continuous cooling curves and time-resolved X-ray diffraction on cooling at a higher rate. The performed experiments allowed for the first time to establish the relationship between the cooling rate, the crystallization temperature, and the X-ray structure of PA 6. The exclusive formation of monoclinic α-crystals is only detected if the crystallization temperature is higher than about 430 K or if the cooling rate is slower than about 5 K s⁻¹, respectively. The formation of α-crystals is increasingly replaced by the development of mesophase with increasing cooling rate, accompanied with a decrease of the temperature of crystallization/ordering. Finally, completely amorphous samples were obtained on cooling faster than about 10² K s⁻¹. The continuous decrease of the temperature of crystallization with increasing cooling rate, regardless of the specific structure formed, precludes a primary effect of the nucleation mechanism on the α-crystal/mesophase polymorphism of PA 6. A preliminary discussion of the effect of molar mass of PA 6 on the cooling rate-dependent polymorphism is also included.