Issue 6/2006
Content (20 Articles)
Finite element simulation of deformation behavior in friction welding of Al-Cu-Mg alloy
Li Qinghua, Li Fuguo, Li Miaoquan, Fu Li, Wan Qiong
Modification of a thermomechanical model to predict constitutive behavior of Al-Mg-Si alloys
J. van de Langkruis, W. H. Kool, S. van der Zwaag
Modeling the viscosity versus temperature and pressure of light hydrocarbon solvents
Adango Miadonye, Loree D’Orsay
Recrystallization texture characteristic and drawability of a warm rolled and cold rolled interstitial-free steel
Zhaodong Wang, Yanhui Guo, Xianghua Liu, Guodong Wang, Peng Zhang
Dry sliding wear behavior of metal matrix composites: A statistical approach
S. Basavarajappa, G. Chandramohan
Evaluating the berkovitz method to predict fatigue loads in mechanical failure investigations
C. O. F. T. Ruckert, J. R. Tarpani, M. T. Milan, W. W. Bose Filho, D. Spinelli
Dry sliding wear behavior of Al 2219/SiCp-Gr hybrid metal matrix composites
S. Basavarajappa, G. Chandramohan, K. Mukund, M. Ashwin, M. Prabu
Analysis and influence of acetylene and propane gas during oxyfuel gas cutting of 1045 carbon steel
Patricia Muñoz-Escalona, Maria Carolina Payares, Minerva Dorta, Ronald Diaz
Microstructure of a nitrided steel previously decarburized
I. Calliari, M. Dabalà, E. Ramous, M. Zanesco, E. Gianotti
Comparative characteristic and erosion behavior of NiCr coatings deposited by various high-velocity oxyfuel spray processes
Hazoor Singh Sidhu, Buta Singh Sidhu, S. Prakash
Forming of magnesium alloys at 100 °C by hydrostatic extrusion
J. Swiostek, J. Göken, D. Letzig, K. U. Kainer
Flexural strength distribution of 3D SiC/SiC composite
Shoujun Wu, Laifei Cheng, Ning Dong, Litong Zhang, Yongdong Xu
Correlation between molten vanadium salts and the structural degradation of HK-type steel superheater tubes
Frederico de Carvalho Nunes, Luiz Henrique de Almeida, André Freitas Ribeiro
Cyclic oxidation behavior of some plasma-sprayed coatings in Na2SO4-60%V2O5 environment
Harpreet Singh, Satya Prakash, Devendra Puri, D. M. Phase
Effect of corrosion on mass loss, and high and low cycle fatigue of reinforcing steel
Ch. Alk Apostolopoulos, D. Michalopoulos
Postmortem raman spectroscopy explaining friction and wear behavior of sintered polyimide at high temperature
P. Samyn, P. De Baets, J. Vancraenenbroeck, F. Verpoort
Microstructure and corrosion behavior of shielded metal arc-welded dissimilar joints comprising duplex stainless steel and low alloy steel
P. Bala Srinivasan, V. Muthupandi, V. Sivan, P. Bala Srinivasan, W. Dietzel