Top

Geotechnical and Geological Engineering

Published in:

24-04-2020 | Original Paper

Numerical Study on the Effectiveness of the Grouting Cable Bolt in Deep Retained Goaf Side Gateroad

Authors: Zhiyi Zhang, Weiming Guan, Hui Chen

Published in: Geotechnical and Geological Engineering | Issue 5/2020

Activate our intelligent search to find suitable subject content or patents.

search-config

AI-assisted search

Off

Abstract

Grouting cable bolt was employed to control the stability of the retaind goaf side gateraod (RGSG) in the Panyidong coalmine by considering severe stress disturbances and soft rock mechanics associated in deep mining environment. To have a deep insight of the effectiveness of the grouting cable bolt supporting on the stability control of the deep RGSG, a FLAC3D numerical model was built according to the geotechnical condition of the Panyidong coalmine, in which strain softening constitutive material was introduced to model the softening behavior of the surrounding rock supported by end-anchored cable bolt or grouting cable bolt. Simulated results demonstrated that: Confining stress release during roadway driving and stress concentration during longwall face retreating are the main driving force to the large deformation of the RGSG supported by end-anchored cable bolt; Grouting cable bolt supporting can improve the stability of the deep RGSG considerably thought providing high bolting strength and grouts injection, and ideally, the RGSG’s roof sag and right coal rib convergence making main contributions to the RGSG section shrinkage could be reduced by 22.0% and 23.0%, 26.6% and 29.4%, 30.2% and 34.9% when the RGSG is supported by grouting cable bolt I, II and III, respectively. Field application also verified that the integrity of the surrounding rock of RGSG was improved and the residual section of the RGSG was large enough to reserve for the second longwall panel mining when the grouting cable bolt technology was applied in the Panyidong coalmine with 850 m depth.

previous article Experimental Study on Ultra-low Friction Effect of Granite Block Under Coupled Static and Dynamic Loads

next article Experimental Study on Mechanical Properties of Anchored Rock-Like Material with Weak Interlayer Under Uniaxial Compression

Dont have a licence yet? Then find out more about our products and how to get one now:

Springer Professional "Wirtschaft+Technik"

Online-Abonnement

Mit Springer Professional "Wirtschaft+Technik" erhalten Sie Zugriff auf:

über 102.000 Bücher
über 537 Zeitschriften

aus folgenden Fachgebieten:

Automobil + Motoren
Bauwesen + Immobilien
Business IT + Informatik
Elektrotechnik + Elektronik
Energie + Nachhaltigkeit
Finance + Banking
Management + Führung
Marketing + Vertrieb
Maschinenbau + Werkstoffe
Versicherung + Risiko

Jetzt Wissensvorsprung sichern!

inform now

Springer Professional "Technik"

Online-Abonnement

Mit Springer Professional "Technik" erhalten Sie Zugriff auf:

über 67.000 Bücher
über 390 Zeitschriften

aus folgenden Fachgebieten:

Automobil + Motoren
Bauwesen + Immobilien
Business IT + Informatik
Elektrotechnik + Elektronik
Energie + Nachhaltigkeit
Maschinenbau + Werkstoffe

Jetzt Wissensvorsprung sichern!

inform now

Brown ET, Hoek E (1978) Trends in relationships between measured in-situ stresses and depth. Int J Rock Mech Min Sci 15:211–215CrossRef

Brook N (1979) Estimating the triaxial strength of rocks. Int J Rock Mech Min Sci 16:261–264CrossRef

David RG, Rafael J (2012) A probabilistic extension to the empirical ALPS and ARMPS systems for coal pillar design. Int J Rock Mech Min Sci 52:181–187CrossRef

Deng Y, Tang J, Zhu X, Fu Y, Dai Z (2010) Analysis and application in controlling surrounding rock of support reinforced roadway in gob-side entry with fully mechanized mining. Min Sci Technol 20:839–845

Deng Y, Wang S (2014) Feasibility analysis of gob-side entry retaining on a working face in a steep coal seam. Int J Min Sci Technol 24:499–503CrossRef

Feng X, Zhang N, Li G, Guo G (2017) Pullout test on fully grouted bolt sheathed by different length of segmented steel tubes. Shock Vib 24:1–16

Itasca Consulting Group Inc (2002) FLAC3D Fast lagrangian analysisof continua in 3dimensions version 3.1 user’s manual. Itasca Consulting Group Inc, Minneapolis

Kurlenya MV, Mirenkov VE, Shutov VA (2014) Rock deformation around stopes at deep levels. J Min Sci 50:1001–1006CrossRef

Lu CP, Liu GJ, Liuet Y (2015) Microseismic multi-parameter characteristics of rockburst hazard induced by hard roof fall and high stress concentration. Int J Rock Mech Min Sci 76:18–32CrossRef

Liu Y, Wang Q, Chen W, Liu M, Hani M (2016) Enhanced coal bed gas drainage based on hydraulic flush from floor tunnels in coal mines. Int J Min Reclam Environ 30(1):37–47CrossRef

Leont’ev Tarasov AVAY (2013) In situ stress state assessment in the Nurkazgan mine. J Min Sci 49:550–556CrossRef

Lee JS, Bang CS, Mok YJ, Joh SH (2000) Numerical and experimental analysis of penetration grouting in jointed rock masses. Int J Rock Mech Min Sci 37:1027–1037CrossRef

Mohammad N, Reddish DJ, Stace LR (1997) The relation between in situ and laboratory rock properties used in numerical modeling. Int J Rock Mech Min Sci 34:289–297CrossRef

Ma Z, Gong P, Fan J, Geng M, Zhang G (2011) Coupling mechanism of roof and supporting wall in gob-side entry retaining in fully-mechanized mining with gangue backfilling. Min Sci Technol 21:829–833

Noack K (1998) Control of gas emissions in underground coal mines. Int J Coal Geol 35:57–82CrossRef

Ning J, Liu X, Qian K, Sun B (2014) Soft-strong supporting mechanism of gob-side entry retaining in deep coal seams threatened by rockburst. Int J Min Sci Technol 24:805–810CrossRef

Qian DY, Zhang N, Pan DJ, Xie ZZ, Shimada H, Wang Y, Zhang CH, Zhang NC (2017) Stability of deep underground openings through large fault zones in argillaceous rock. Sustainability 9(11):1–28CrossRef

Qian DY, Zhang N, Zhang MW, Shimada H, Cao P, Chen YL, Wen K, Yang S, Zhang NC (2017) Application and evaluation of ground surface pre-grouting reinforcement for 800-m-deep underground opening through large fault zones. Arab J Geosci 10(13):1–20CrossRef

Shabarov AN, Selivonik VG, Sidorov DV (2000) Calculation of pillar unloading parameters during mining ofore deposits. J Min Sci 36(1):22–29CrossRef

Trubetskoy KN, Ruban AD, Zaburdyaev VS (2011) Characteristics of methane release in highly productive coal mines. J Min Sci 47:467–475CrossRef

Utsuki S (2013) In-situ experimental studies on improvement of deformability of rock masses by grout treatment. Jpn Comm Rock Mech 9:7–8

Yuan L (2008) Gas distribution of the mined-out side and extraction technology of first mined key seam relief-mining in gassy multi-seams of low permeability. J China Coal Soc 33:1362–1367

Yang W, Lin BQ, Yan Q, Zhai C (2014) Stress redistribution of longwall mining stope and gas control of multi-layer coal seams. Int J Rock Mech Min Sci 72:8–15CrossRef

Yang SQ, Xu P, Ranjith PG (2014) Evaluation of creep mechanical behavior of deep-buried marble under triaxial cyclic loading. Arab J Geosci 8(9):6567–6582CrossRef

Yan S, Bai JB, Wang X, Huo L (2013) An innovative approach for gateroad layout in highly gassy longwall top coal caving. Int J Rock Mech Min Sci 59:33–41CrossRef

Zhang ZZ, Bai JB, Chen Y, Yan S (2015) An innovative approach for gob-side entry retaining in highly gassy fully-mechanized longwall top-coal caving. Int J Rock Mech Min Sci 80:1–11CrossRef

Zhang NC, Zhang N, Esterleet J (2016a) Optimization of gateroad layout under a remnant chain pillar in longwall undermining based on pressure bulb theory. Int J Min Reclam Environ 30(2):128–144CrossRef

Zhang YQ, Sun LL, Zhang WZ, Cao LD (2013) The numerical simulation and supporting design of gob-side entry retaining in gradient medium thick coal seam. Appl Mech Mater 368–370:1812–1815CrossRef

Zhang ZY, Shimada H, Qian DY, Sasaoka T (2016b) Application of the retained gob-side gateroad in a deep underground coalmine. Int J Min Reclam Environ 30(5–6):371–389CrossRef

Zhao TB, Guo WY, Yin YC (2015) Tan YL (2015) Bolt pull-out tests of anchorage body under different loading rates. Shock Vib 4:1–8

Zolfaghari A, SohrabiBidar A, MalekiJavan MR (2015) Evaluation of rock mass improvement due to cement grouting by Q-system at Bakhtiary dam site. Int J Rock Mech Min Sci 74:38–44CrossRef

Zhang ZZ, Bai JB, Chen Y, Yan S (2019) Stability control for gob-side entry retaining with supercritical retained entry width in thick coal seam longwall mining. Energies 12(1375):1–16

Zhang ZZ, Deng M, Bai JB, Yu XY, Wu QH, Jiang LS (2020) Strain energy evolution and conversion under triaxial unloading confining pressure tests due to gob-side entry retained. Int J Rock Mech Min Sci 126:1–10

Title: Numerical Study on the Effectiveness of the Grouting Cable Bolt in Deep Retained Goaf Side Gateroad
Authors: Zhiyi Zhang
Weiming Guan
Hui Chen
Publication date: 24-04-2020
Publisher: Springer International Publishing
Published in: Geotechnical and Geological Engineering / Issue 5/2020
Print ISSN: 0960-3182
Electronic ISSN: 1573-1529
DOI: https://doi.org/10.1007/s10706-020-01307-4

Springer Professional

Abstract

Please log in to get access to your license.

Dont have a licence yet? Then find out more about our products and how to get one now:

Springer Professional "Wirtschaft+Technik"

Springer Professional "Technik"

Other articles of this Issue 5/2020

Structural Characteristics of the Overlying Strata in a Fully Mechanized Longwall Face with the Low-Position Thick-Hard Roof

Effects of Drying and Soil-Base Interface on the Behavior of an Expansive Soil Mixture

Compressibility and the Effects of Structure of Tropical Clay in Incremental Loading Oedometer Tests

Experimental Study on Mechanical Properties of Anchored Rock-Like Material with Weak Interlayer Under Uniaxial Compression

Prediction of Mechanical Properties of Sedimentary Type Rocks Using Rotary Drilling Parameters

Experimental Research of Excavation Disturbance Effect Due to Trenchless Construction by Using Distributed Strain Sensing Technique