On the Morphology Changes of Al and Al-Cu Powder After Laser Melting

Gas-atomized powders are commonly used in additive manufacturing, specifically laser powder bed fusion, due to their high flowability during recoating. Morphological changes can occur in particles that are irradiated by the laser during additive manufacturing, but are not incorporated into the melt pool. These irradiated particles will affect the rheology of the recycled powder in subsequent builds, potentially leading to failures due to uneven powder flow or spatial distribution. Thus, a better understanding of mechanisms that degrade the sphericity of powder after being laser irradiated is needed. This research examines morphological changes in Al and Al-Cu eutectic powders after laser melting. Two complementary approaches were taken. First, particles found along the edges of line scans following high-power (300 W) laser irradiation were characterized. The collected particles displayed morphological anomalies not observed in the as-received powder. Then, to gain a more quantitative and controlled perspective on morphological evolution, the same base powders were dispersed onto glass substrates and irradiated with a low-power (6.5 W) CW laser diode. This approach, which permits characterization of specific particles before and after laser irradiation, clearly shows laser-induced changes in the surface morphology of particles in the form of dents and rifts. These results suggest that isolated melting and resolidification of particles contained within their respective oxide shells can occur at the relatively low laser energy densities present at the edges of laser melt tracks. Thermal stresses developing in the oxide shell during cooling can account for the observed morphological changes in the context of shell-buckling theory.