Issue 2/2006
Content (15 Articles)
Generalization of the results from investigations on perfecting the design of journal bearings for large steam turbines for nuclear power stations
A. S. Lisyanskii, N. P. Egorov, M. I. Shklyarov, N. S. Lebed’ko, A. F. Spiridonov, R. K. Koval’skii, A. E. Yazykov
Studying the advisability of using gas-turbine unit waste gases for heating feed water in a steam turbine installation with a type T-110/120-12.8 turbine
A. D. Trukhnii, G. D. Barinberg, Yu. A. Rusetskii
Experimental investigations into the efficiency of a device for removing moisture from the inlet flow in double-flow low-pressure cylinders of cogeneration turbines
L. L. Simoyu, E. I. Efros, A. G. Shempelev, B. B. Kalinin, Yu. A. Chirkov
Retrofitting the schematic and layout solutions of the condensate-feedwater path and its equipment of turbine units at thermal and nuclear power stations
N. N. Trifonov, E. V. Kovalenko, I. V. Ignat’ev, Yu. V. Shalkevich
The efficiency of technical retrofitting of cogeneration stations using combined-cycle plants
L. S. Popyrin, M. D. Dil’man, G. M. Belyaeva
Calculation of regulation systems with two auxiliary controlled variables
V. Ya. Rotach, Yu. N. Vishnyakova
Comparative analysis of correlations for calculating subcooled boiling heat transfer
N. D. Agafonova, M. A. Gotovskii, I. L. Paramonova
A thermodynamic method for determining the cavitation characteristics of pumps
K. K. Klimovskii, I. M. Pinke
The introduction of the software-and-hardware systems developed by ZAO interavtomatika and ZAO MST tornado in power units at thermal power stations
G. V. Chirkov, S. N. Pokrovskii, Yu. P. Starostin
The effectiveness of using controlled power turbines in gas-turbine units and regenerative-cycle and simple-cycle engines
O. V. Komarov, B. S. Revzin, Yu. M. Brodov