Skip to main content
main-content

Tipp

Weitere Kapitel dieses Buchs durch Wischen aufrufen

2020 | OriginalPaper | Buchkapitel

26. Examining Partial Circuits

verfasst von: Jonathan Bartlett

Erschienen in: Electronics for Beginners

Verlag: Apress

share
TEILEN

Abstract

We will end our discussion of amplification by discussing partial circuits. Oftentimes you will need to design a circuit which connects to another circuit, either powering it or receiving power from it. For instance, in the amplification circuits from Chapter 25, the outputs were connected to a speaker. They could also be connected to another amplifier or to a stomp box (a device to modulate the incoming signal in some way) or a recording circuit.
Fußnoten
1
We haven’t talked about current sources much in this book. However, for completeness, I should note that if you have a current source, you should replace it with an open circuit (i.e., a gap in the wire) when calculating Thévenin resistance.
 
Metadaten
Titel
Examining Partial Circuits
verfasst von
Jonathan Bartlett
Copyright-Jahr
2020
Verlag
Apress
DOI
https://doi.org/10.1007/978-1-4842-5979-5_26

Premium Partner