In this paper, a simple and efficient electrochemical sensor based on indium sulfide nanosheet arrays (In2S3 NSAs) grown on 3D graphene (3D Gr) has been developed. 3D Gr was obtained by chemical vapor deposition (CVD) and In2S3 NSAs were prepared …

The rewritable bistable memory characteristics have been studied in polymethyl methacrylate (PMMA) and carboxylated multi-walled carbon nanotubes (CNT) composite films. The sandwich structure FTO/PMMA + CNTs/Ag devices were prepared by spin …

Different compositions of Zn1−xCoxO (0 ≤ x ≤ 0.15) nanocrystalline compounds were produced in terms of ball milling method, thin films of these compounds were prepared by electron beam evaporation method. XRD pattern was utilized to study the …

We report here, the Ca9La(PO4)5(SiO4)F2:1 mol%Eu3+ phosphor via doping of chloride, molybdate, vanadate, sulfate, and tungstate ions that were synthesized by high-temperature solid-state reaction method. The phase formation was confirmed by X-ray …

In this work for the first time, a new bis(4-benzylpiperazine-1-carbodithioato-k2S,Sʹ)nickel(II) complex (hereafter caged nickel sulfide) has been used to fabricate the capacitive-type and resistive-type sensor. The surface consisted of 2D plates …

Frequency selective absorbing property (FSAP) is a key to realize radar frequency selective surfaces' stealth technology, which has great application prospects in national military industry. Different from traditional metal materials, herein …

A novel nanostructured silver chromite with the chemical formula Ag2Cr2O4 was synthesized at 400 °C by simple, cost effective, flash auto-combustion method. The average crystallite size was found to be 76.6 nm by crystallographic study of X-ray …

Microstructure of Cu–Ni–Si alloys, especially morphology, amount and size of Ni–Si intermetallics, was controlled by heat and thermal–mechanical treatment, and then its influence on electrical breakdown behavior was investigated systematically.

Mono-like cast silicon (ML C-Si) passivated emitter and rear cell (PERC) solar cells with high performance and low price are becoming popular in the modern PV market. In this work, mono-like cast silicon PERC solar cells with B and Ga co-doping …

We report the synthesis and promising electrical properties of a new lead-free ferroelectric ceramic K0.5Bi0.5TiO3-NaNbO3 (KBT-NN), which can be a candidate of choice for future sensors, FeRAM etc. Mixed-oxide method has been employed to prepare …

Owing to the growing development of electronics manufacturing in tandem with the need for integration of electronic devices in the smallest size available, the need for multifunctional detectors becomes an insisted demand. Hence, the present …

ZrO2–TiO2 heterostructure with 5 mol% of ZrO2 was synthesized by the sol–gel method and calcined at different temperatures (300–600 °C). The photocatalysts were characterized by thermal analysis, X-ray diffraction, physisorption of N2, diffuse …

A new strategy is reported to enhance the upconversion (UC) luminescence emission of LiYF4:Yb, Er nanocrystals (NCs) using magnesium as a dopant. We carried out systematic experimental studies on the crystal structure, grain size, and UC emitting …

The series of La(Mg0.5−xNixSn0.5)O3 microwave ceramics were investigated for application in sub-6 GHz patch array antenna. The microwave dielectric characteristics of La(Mg0.5−xNixSn0.5)O3 ceramics are determined using X-ray diffraction patterns …

Nanocrystalline Gd-doped soft Mn–Zn spinel ferrites with a generic formula Mn0.5Zn0.5Fe2−xGdxO4 (x = 0.00, 0.04, 0.08 and 0.12) were synthesized using standard chemical co-precipitation technique. The powder X-ray diffractograms confirmed the …

GdMnO3 (GMO) ceramics were prepared by solid-state reaction method, the structure, defects, dielectric, and magnetic properties of GMO ceramics sintered at different temperatures have been studied. Characterization by XRD indicates that impurity …

Two compounds with the formula La0.8Ba0.1Bi0.1FeO3 have been prepared by the sol–gel (LBBFO-SG) and the auto-combustion (LBBFO-AC) preparation methods. The effect of the preparation method on structural, morphology, vibrational, electrical, and …

This paper reports an approach for improving the photoluminescence characteristics of red-emitting Y0.95(P0.6V0.4)O4:Eu0.05 phosphors, with the incorporation of Al3+ ions, using a chemical co-precipitation process. In this paper, structural …

BiFeO3 is the most important single-phase room temperature multiferroic materials. In this work, the structure, ferroelectric and magnetic properties of ternary SmFeO3 and BaTiO3 co-substituted BiFeO3 ceramics prepared by standard solid-state …

Single-crystal $$\hbox {BaTiO}_3$$BaTiO3 (BTO) films were prepared by pulsed laser deposition (PLD) on (100) $$\hbox {SrRuO}_3$$SrRuO3(SRO) buffered $$\hbox {SrTiO}_3$$SrTiO3(STO) substrates, which were treated by rapid thermal processing (RTP) in …