Abstract
Because of the continuous production of large amount of waste tires, the disposal of waste tires represents a major environmental issue throughout the world. This paper reports the utilization of waste tires (hard-to-dispose waste) as a precursor in the production of activated carbons (pollution-cleaning adsorbent). In the preparation of activated carbon (AC), waste rubber tire (WRT) was thermally treated and activated. The tire-derived activated carbon was characterized by means of scanning electron microscope, energy-dispersive X-ray spectroscopy, FTIR spectrophotometer, and X-ray diffraction. In the IR spectrum, a number of bands centred at about 3409, 2350, 1710, 1650, and 1300–1000 cm−1 prove the present of hydroxyl and carboxyl groups on the surface of AC in addition to C═C double bonds. The developed AC was tested and evaluated as potential adsorbent removal of chromium (III). Experimental parameters, such as contact time, initial concentration, adsorbent dosage and pH were optimized. A rapid uptake of chromium ions was observed and the equilibrium is achieved in 1 h. It was also found that the adsorption process is pH dependent. This work adds to the global discussion of the cost-effective utilization of waste rubber tires for waste water treatment.
Similar content being viewed by others
References
Alexandre-Franco M, Fernández-González C, Macías-García A, Gómez-Serrano V (2008) Uptake of lead by carbonaceous adsorbents developed from tire rubber. Adsorption 14:591–600
Alexandre-Franco M, Fernández-González C, Alfaro-Domínguez M, Gómez-Serrano V (2011) Adsorption of cadmium on carbonaceous adsorbents developed from used tire rubber. J Environ Manag 92:2193–2200
Almazan-Almazan MC, Paredes JI, Perez-Mendoza M, Domingo-Garcia M, Fernandez-Morales I, Martinez-Alonso A, Lopez-Garzon FJ (2006) Surface characteristics of activated carbons obtained by pyrolysis of plasma pretreated PET. J Phys Chem B 110:11327–11333
Atieh MA, Bakather OY, Tawabini BS, Bukhari AA, Khaled M, Alharthi M, Fettouhi M, Abuilaiwi FA (2010) Removal of chromium (III) from Water by using modified and nonmodified carbon nanotubes. J Nanomater 1–9
Chan OS, Cheung WH, McKay G (2011) Preparation and characterisation of demineralised tyre derived activated carbon. Carbon 49:4674–4687
Chantawong V (2004) Adsorption of Heavy Metals by Montmorillonite, The Joint International Conference on “Sustainable Energy and Environment (SEE)”1-3 December, Hua Hin, Thailand, 548–551
Chuan MC, And Liu JC (1996) Release behavior of chromium from tannery sludge. Wat Res 30:932–938
Cossich ES, Tavares CRG, Ravagnani TMK (2002) Biosorption of chromium(III) by Sargassum sp. Biomass Electron J Biotechnol 5(2):133–141
Deng H, Yang L, Tao GH, Dai JL (2009) Preparation and characterization of activated carbon from cotton stalk by microwave assisted chemical activation—application in methylene blue adsorption from aqueous solution. J Hazard Mater 166:1514–1521
Fei-Lian FH, Chen W, Xing B, Zhu L (2011) Sorption of apolar and polar organic contaminants by waste tire rubber and its chars in single- and bi-solute systems. Environ Pollut 159:850–857
Garcia ITS, Nunes MR, Carreo NLV, Wallaw WM, Fajardo HV, Probst LFD (2007) Preparation and characterization of activated carbons from thread of tire waste. Pol’ımeros 17:329–333
Greenwood NN, Earnshaw A (1989) ×. Pergamon, Oxford
Gupta VK, Mittal A, Gajbe V, Mittal J (2006a) Removal and recovery of the hazardous azo dye acid orange 7 through adsorption over waste materials: bottom ash and de-oiled soya. Ind Eng Chem Res 45:1446–1453
Gupta VK, Mittal A, Kurup L, Mittal J (2006b) Adsorption of a hazardous dye, erythrosine, over hen feathers. J Colloid Interface Sci 304(1):52–57
Gupta VK, Jain R, Varshney S (2007a) Electrochemical removal of the hazardous dye Reactofix Red 3 BFN from industrial effluents, 2007. J Colloid Interface Sci 312(2):292–296
Gupta VK, Jain R, Varshney S (2007b) Removal of Reactofix golden yellow 3 RFN from aqueous solution using wheat husk—an agricultural waste. J Hazard Mater 142:443–448
Gupta VK, Rastogi A (2008a) Equilibrium and kinetic modelling of cadmium (II) biosorption by nonliving algal biomass Oedogonium sp. from aqueous phase. J Hazard Mater 153:759–766
Gupta VK, Rastogi A (2008b) Sorption and desorption studies of chromium (VI from nonviable cyanobacterium Nostoc muscorum biomass. J Hazard Mater 154:347–354
Gupta VK, Rastogi A (2009a) Biosoprtion of hexavalent chromium by raw and acid-treated green alga Oedogonium hatei from aqueous solutions. J Hazard Mater 163:396–402
Gupta VK, Goyal RN, Sharma RA (2009b) Novel PVC membrane based alizarin sensor and its application; Determination of vanadium, zirconium and molybdenum. Inter J Electrochem Sci 4:156–172
Gupta VK, Al Khayat M, Singha AK, Pal MK (2009c) Nano level detection of Cd (II) using poly(vinyl chloride) based membranes of Schiff bases. Anal Chimica Acta 634:36–43
Gupta VK, Rastogi A, Nayak A (2010) Adsorption studies on the removal of hexavalent chromium from aqueous solution using a low cost fertilizer industry waste material. J Colloid and Interface Sci 342(1):135–141
Gupta VK, Agarwal S, Saleh TA (2011a) Synthesis and characterization of alumina-coated carbon nanotubes and their application for lead removal. J Hazard Mater 185(1):17–23
Gupta VK, Agarwal S, Saleh TA (2011b) Chromium removal combining the magnetic properties of iron oxide with adsorption properties of carbon nanotubes. Water Res 45(6):2207–2212
Helleur R, Popovic N, Ikura M, Stanciulescu M, Liu D (2001) Characterization and potential applications of pyrolytic char from ablative pyrolysis of used tires. J Anal Appl Pyrol 58–59:813–824
Huang H, Tang L, Wu CZ (2003) Characterization of gaseous and solid product from thermal plasma pyrolysis of waste rubber. Environ Sci Technol 37:4463–4467
Min A, Harris AT (2006) Influence of carbon dioxide partial pressure and fluidization velocity on activated carbons prepared from scrap car tyre in a fluidized bed. Chem Eng Sci 61:8050–8059
Nakagawa K, Namba A, Mukai SR, Tamon H, Ariyadejwanich P, Tanthapanichakoon W (2004) Adsorption of phenol and reactive dye from aqueous solution on activated carbons derived from solid wastes. Water Res 38(7):1791–1798
Rana P, Mohan N, Rajagopal C (2004) Electrochemical removal of chromium from wastewater by using carbon aerogel electrodes. Water Res 38:2811–2820
Richard FC, Bourg ACM (1991) Aqueous geochemistry of chromium: a review. Wat Res 25:807–816
Rutland FH (1991) Environmental compatibility of chromium-containing tannery and other leather product wastes at land disposal sites. J Am Leather Chem Assoc 86:364–375
Saleh TA (2011) The influence of treatment temperature on the acidity of MWCNT oxidized by HNO3 or a mixture of HNO3/H2SO4. Appl Surf Sci 257:7746–7751
Saleh TA, Gupta VK (2011a) Functionalization of MWCNT with tungsten oxide and its application for sun-light-induced degradation of rhodamine B. J Colloid Interface Sci 362(2):337–344
Saleh TA, Gupta VK (2011b) Synthesis of MWCNT/MnO2 and their application for simultaneous oxidation of arsenite and sorption of arsenate. Appl Catal B Environ 106(1–2):46–53
San Miguel G, Fowler GD, Sollars CJ (2002) The leaching of inorganic species from activated carbons produced from waste tyre rubber. Water Res 36:1939–1946
San-Miguel G, Fowler GD, Sollars CJ (2002) Adsorption of organic compounds from solution by activated carbons produced from waste tyre rubber. Sep Sci Technol 37(3):663–676
Stellmach JJ (1990) The commercial success of chrome tanning: a study and commemorative. J Am Leather Chem Assoc 85(11):407–454
Tanthapanichakoon W, Ariyadejwanich P, Japthong P, Nakagawa K, Mukai SR, Tamon H (2005) Adsorption-desorption characteristics of phenol and reactive dyes from aqueous solution on mesoporous activated carbon prepared from waste tires. Water Res 39(7):1347–1353
Yang J, Qiu K (2009) Preparation of activated carbon by chemical activation under vacuum. Environ Sci Technol 43:3385–3390
Zhang N, Suleiman JS, He M, Hu B (2008) Chromium(III)-imprinted silica gel for speciation analysis of chromium in environmental water samples with ICP-MS detection. Talanta 75:536–543
Acknowledgment
The author(s) would like to acknowledge the support provided by King Abdulaziz City for Science and Technology (KACST) through the Science & Technology Unit at King Fahd University of Petroleum & Minerals (KFUPM) for funding this work through project No.10-WAT1400-04.as part of the National Science, Technology and Innovation Plan
Author information
Authors and Affiliations
Corresponding author
Additional information
Responsible editor: Philippe Garrigues
Rights and permissions
About this article
Cite this article
Gupta, V.K., Ali, I., Saleh, T.A. et al. Chromium removal from water by activated carbon developed from waste rubber tires. Environ Sci Pollut Res 20, 1261–1268 (2013). https://doi.org/10.1007/s11356-012-0950-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11356-012-0950-9