Abstract
The study of the porosimetric data obtained from intrusion, extrusion, and reintrusion of mercury in limestone samples from the region of the sphinx reveals the characteristics of the pore system and allows analysis of durability factors.
The pore system in all these rocks consists of “ink-bottle” pores. As the initial intrusion and extrusion have been completed, some mercury always remains in the sample. This trapped mercury represents the volume of large voids of the ink-bottle pore system. The distribution of the volume of the narrow throats of this system is revealed by the reintrusion curves.
The curves obtained by plotting extrusion and reintrusion volumes against corresponding pressures enclose a loop. These curves relate to pore throats only. As entrapment of mercury does not occur in these pores, their distribution frequency and sorting seem to cause this hysteresis.
The pressure/volume data also have been interpreted in terms of work needed to inject and extrude mercury from the pores. This thermodynamic analysis of the data has provided an additional, although less well-defined, means to characterize the porous stones.
We have used in this study the model-dependent pore-size distributions and model-independent thermodynamic properties to develop durability factors. The factors based upon the combination of pore sizes in the range of <0.5, 0.5-5, and >5 µm precisely fit the observed durability of limestones at the sphinx, some of which have been exposed for more than 5,000 yr to the ambient atmosphere.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References Cited
Cassaro, M. A., K. L. Gauri, M. Sharifinassab, and A. Sharifian, 1982, On the strength and deformation properties of Indiana limestone and concrete in presence of salts;in K. L. Gauri and J. A. Gwinn, eds., Fourth international congress on deterioration and preservation of stone objects: University of Louisville, Louisville, KY, p. 57–76.
Chowdhury, A. N., A. Punuru, and K. L. Gauri, 1990, Weathering of limestone beds at the Great Sphinx: Environmental Geology and Water Science, v. 15, pp. 217–223.
Dullien, F. A. L., and V. K. Batra, 1970, Determination of structure of porous media;in R. J. Nunge, ed., Flow through porous media: American Chemical Society, Washington, D.C., p. 1–30.
Everett, D. H., 1961, The thermodynamics of frost damage to porous solids: Transactions of the Faraday Society, v. 57, p. 1541–1557.
Gauri, K. L., 1984, Geologic study of the sphinx: American Research Center in Egypt, Newsletter, 127, p. 19–27.
Gauri, K. L., and G. C. Holdren, 1981, Deterioration of the stone of the Great Sphinx: American Research Center in Egypt, Newsletter, 114, p. 35–47.
Honeyborne, D. B., and P. B. Harris, 1958, The structure of porous building stone and its relation to weathering behavior: Proceedings, 10th symposium of the Colston research society, Butterworths Scientific Publications, London, p. 343.
Kaneuji, M., 1978, Correlation between pore size distribution and freeze thaw durability of coarse aggregate in concrete: Report JHRP-IN-78-15, Joint Highway Research Project, Purdue University, Reproduced by the National Technical Information Service. U.S. Department of Commerce, Springfield, VA 22161, p. 142.
Kaneuji, M., D. N. Winslow, and W. L. Dolch, 1980, The relationship between an aggregate's pore size distribution and its freeze thaw durability in concrete: Cement and Concrete Research, v. 10, p. 433–441.
Lowell, S., and J. E. Shield, 1983, Hysteresis, entrapment and wetting angle in mercury porosimetry: Journal of Colloid and Interface Science, v. 83, p. 273–278.
Lowell, S., and J. E. Shield, 1984, Powder surface area and porosity;in B. Scarlett, ed., Powder technology series, 2nd ed., Chapman & Hall, New York, 234 p.
Lowell, S., and J. E. Shields, 1981, Influence of contact angle on hysteresis in mercury porosimetry: Journal of Colloid and Interface Science, v. 80, p. 192–196.
Robertson, W. D., 1982, Evaluation of the durability of limestone masonry in historic buildings;in K. L. Gauri and J. A. Gwinn, eds., Fourth international congress on deterioration and preservation of stone objects: University of Louisville, Louisville, KY, p. 261–278.
Schaffer, R. J., 1932, The weathering of natural stones: Department of Scientific and Industrial Research special report, 18, Reprinted by the Building Research Establishment (1972): Garston Watford, WO27JR, England, 149 p.
Wardlaw, N. C., 1976, Pore geometry of carbonates as revealed by pore casts and capillary pressure data: American Association of Petroleum Geologists Bulletin, v. 60, p. 245–257.
Wardlaw, N. C., and M. McKellar, 1981, Mercury porosimetry and the interpretation of pore geometry in sedimentary rocks and artificial models: Powder Technology, v. 29, p. 127–143.
Wardlaw, N. C., and R. P. Taylor, 1976, Mercury capillary pressure curves and the interpretation of pore structure and capillary behavior in reservoir rocks: Bulletin Canadian Petroleum Geologists, v. 24, p. 225–262.
Washburn, E. W., 1921, Note on a method of determining the distribution of pore sizes in a porous material: Proceedings of the National Academy of Sciences of the United States of America, v. 7, p. 115–116.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Punuru, A.R., Chowdhury, A.N., Kulshreshtha, N.P. et al. Control of porosity on durability of limestone at the great sphinx, Egypt. Environ. Geol. Water Sci 15, 225–232 (1990). https://doi.org/10.1007/BF01706414
Issue Date:
DOI: https://doi.org/10.1007/BF01706414