Abstract
Instantaneous backflow through central clearance of bileaflet heart valves at the instant of closure is investigated. An Edwards-Duromedics valve in the mitral position is employed to measure the transient pressures near the entrance and exit region in an in vitro flow chamber. A region surrounding the clearance is modelled, and two-dimensional quasi-steady-state numerical simulations are performed, with the measured transient pressure difference across the clearance as a driving force for the flow. The results show that pressure difference several times larger than the driving pressure used to close the valve is established across the clearance for about 0·5 ms at the moment of closure. The resulting average wall shear stress is an order of magnitude larger than the turbulent Reynolds stresses reported distal to the valve during opening. A local jump in the shear stress distribution and fall in the pressure distribution are observed at the entrance region. Rounding of the corners in the channel entrance attenuates these spikes. The results of the study indicate that backflow through clearance at closure may be one reason for the haemolysis and thrombosis associated with mechanical heart valves, despite the short duration of the flow field.
Similar content being viewed by others
References
Chandran, K. B. (1988): ‘Heart valve prostheses:in vitro flow dynamics’in J. Webster (Ed.): ‘Encyclopedia of medical devices and instrumentation’ (John Wiley & Sons, New York) Vol. 3, pp. 1475–1483
Chandran, K. B. (1992): ‘Cardiovascular biomechanics’ (New York University Press, New York)
Chandran, K. B., Lee, C. S., andChen, L. D. (1994): ‘Pressure field in the vicinity of mechanical valve occluders at the instant of valve closure: correlation with cavitation initiation,’J. Heart Valve Dis.,3, suppl. 1, pp. 565–576
Collins, M. W. (1991): ‘Modelling flow in arteries and arterial prosthesis.’ Commision of the European Communities, Proc. Expert Meeting, Liverpool, UK
Haggag, Y. A. M. (1990): ‘A comparative study of the shear stresses induced in the leakage back flow produced by four types of heart valves prostheses,’IMechE. J. Eng. Med., 204, pp. 111–114
Jones, I. P., Kightley, J. R., Thompson, C. P., andWilkes, N. S. (1985): ‘FLOW3D, a computer program for the prediction of laminar and turbulent flow, and heat transfer: release 1.’ AERE-R 11825 Computational Fluid Dynamic Services, Oxfordshire, UK
Kinsley, R., Antunes, P., andColsen, P. (1986): ‘St. Jude Medical valve replacement,’J. Thorac. Cardiovasc. Surg.,92, pp. 349–360
Lee, C. S., Clausen, J. D., andChandran, K. B. (1991): ‘Flow dynamics in the disc clearance region of a bileaflet mechanical heart valve prosthesis during the closing phase.’ Proc. 3rd USA-China-Japan Conf. on Biomechanics, Georgia Institute of Technology, Atlanta, Georgia, pp. 137–138
Lee, C. S. (1993): ‘Dynamics associated with the closure of mechanical heart valves: cavitation and clearance flow,’ PhD thesis, University of Iowa, Iowa City, USA
Lee, C. S., Chandran, K. B., andChen, L. D. (1994): ‘Cavitation dynamics of mechanical heart valve prostheses,’Artif. Org.,18, pp. 758–767
Leuer, L. (1986): ‘In vitro evaluation of drive parameters and valve selection for the total artificial heart.’ Annual meeting of the Canadian Council of Cardiovascular Perfusionists, Ottawa, Ontario, Canada
Morishita, Y., Arikawa, K., Yamashita, M., Yuda, T., andShimokawa, S. (1987): ‘Fatal hemolysis due to unidentified causes following mitral valve replacement with bileaflet tilting disc valve prosthesis,’Heart Vessels,3, pp. 100–103
Reif, T. H. (1991): ‘A numerical analysis of the backflow between the leaflets of a St. Jude medical cardiac valve prosthesis,’J. Biomech.,24, pp. 733–741
Yoganathan, A. P., Woo, Y. R., andSung, H. W. (1986): ‘Turbulent shear stress measurements in the vicinity of aortic valve prostheses,’Ibid.,119, pp. 433–442
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Lee, C.S., Chandran, K.B. Numerical simulation of instantaneous backflow through central clearance of bileaflet mechanical heart valves at closure: shear stress and pressure fields within clearance. Med. Biol. Eng. Comput. 33, 257–263 (1995). https://doi.org/10.1007/BF02510497
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02510497