Abstract
The stacking fault energies of the fee alloy series Fe-28 Ni to pure Ni were investigated using X-ray diffraction line profile analysis. A minimum stacking fault energy of about 70 mJ/m2 occurs at the approximate composition of Fe-40 pct Ni. From this point, the lower nickel alloys rapidly increase to a very high stacking fault energy, estimated to be 200 mJ/m2, while the energies of the high Ni alloys rise linearly to the Ni value of 214 mJ/m2. Anomalous reductions of the lattice parameter after cold work were found for the low nickel alloys; this was interpreted as evidence for Fe3Ni ordering and corrections to the stacking fault energy were made.
Similar content being viewed by others
References
H. M. Ledbetter and R. P. Reed:J. Phys. Chem. Ref. Data, 1973, vol. 2, pp. 531–618.
W. B. Pearson:A Handbook of Lattice Spacings and Structures of Metals and Alloys, pp. 63841, Pergamon Press, New York, 1958.
P. R. Swann:Corrosion, 1963, vol. 19, pp. 102t-l12t.
D. L. Douglass, G. Thomas, and W. R. Roser:Corrosion, 1964, vol. 20, pp. 15t-28t.
P. C. J. Gallagher:Met. Trans., 1970, vol. 1, pp. 2429–61.
R. P. Reed and R. E. Schramm:J. Appl. Phys., 1974, vol. 45, pp. 4705–11.
J. W. Christian and J. Spreadborough:Phil Mag., 1956, vol. l, pp. 1069–75.
N. I. Noskova and V. A. Pavlov:Phys. Met. Metallogr., 1962, vol. 14, no. 6, pp. 86–89.
A. J. Goldman and C. N. J. Wagner:Acta Met., 1963, vol. 11, pp. 405–13.
B. Henderson:J. Inst. Metals, 1963-64, vol. 92, pp. 55–56.
N. I. Noskova and V. A. Pavlov:Phys. Met. Metallogr., 1965, vol. 20, no. 3, pp. 109–14.
T. Sambongi:J. Phys. Soc. Jap., 1965, vol. 20, pp. 1370–74.
F. Haussermann and M. Wilkens:Phys. Status Solidi, 1966, vol. 18, pp. 609–24.
P. Humble, M. H. Loretto, and L. M. Clarebrough:Phil. Mag., 1967, vol. 15, pp. 297–303.
L. Delehouzee and A. Deruyttere:Acta Met., 1967, vol. 15, pp. 727–34.
B. E. P. Beeston, I. L. Dillamore, and R. E. Smallman:Metal Sci. J., 1968, vol. 2, pp. 12–14.
B. E. P. Beeston and L. K. France:J. Inst. Metals, 1968, vol. 96, pp. 105–07.
E. D. Butakova, K. A. Malyshev, and N. I. Noskova:Fiz. Metal. Metalloved., 1973, vol. 35, no. 3, pp. 662–64.
H. Oettel:Phys. Status Solidi. (a), 1971, vol. 6, pp. 265–72.
B. E. Warren:Progress in Metal Physics, vol. 8, pp. 147–202, Pergamon Press, New York, 1959.
S. Sato:Jap. J. Appl. Phys., 1962, vol. 1, pp. 210–17.
D. K. Chaudhuri: 1969, Vanderbilt Univ., Ph.D. Thesis.
D. K. Chaudhuri, P. A. Ravindran, and J. J. Wert:J. Appl. Phys., 1972, vol. 43, pp. 778–88.
C. P. Gazzara, J. J. Stiglich, Jr., F. P. Meyer, and A. M. Hansen:Advances in X-Ray Analysis, vol. 12, p. 257, Plenum Press, New York, 1969.
R. E. Schramm: National Bureau of Standards Tech. Note 600, 1971.
R. L. Rothman and J. B. Cohen:Advances in X-Ray Analysis, vol. 12, p. 208, Plenum Press, New York, 1969.
Residual Stress Measurement by X-Ray Diffraction, SAE J. 784a, p. 51, Society of Automotive Engineers, New York, 1971.
R. P. Reed and R. E. Schramm:J. Appl. Phys., 1969, vol. 9, pp. 3453–58.
B. E. Warren and E. P. Warekois:Acta Met., 1955, vol. 3, pp. 473–79.
R. P. I. Adler and C. N. J. Wagner:J. Appl. Phys., 1962, vol. 33, pp. 3451–58.
R. E. Schramm and R. P. Reed:Met. Trans. A, 1975, vol. 6A, pp. 1345–51.
R. Fawley, M. A. Quader, and R. A. Dodd:Trans. TMS-AIME, 1968, vol. 242, pp. 771–76.
W. B. Pearson:op. cit., p. 411.
Y. Bando:J. Phys. Soc. Jap., 1961, vol. 16, pp. 2342–43.
S. Kachi, Y. Bando, and S. Higuchi:Jap. J. Appl. Phys., 1962, vol. 1, pp. 307–13.
G. Hausch and H. Warlimont:Phys. Lett., 1971, vol. 36A, pp. 415–16.
G. Hausch and H. Warlimont:Phys. Lett., 1972, vol. 41 A, pp. 437–39.
R. J. Wakelin and E. L. Yates:Proc. Phys. Soc., London, Sect. B, 1953, vol. B66, pp. 221–40.
E. Peissker:Acta Met., 1965, vol. 13, pp. 419–31.
G. Thomas:J. Aust. Inst. Metals, 1963, vol. 8, pp. 80–90.
Author information
Authors and Affiliations
Additional information
This manuscript is a contribution of the National Bureau of Standards and not subject to copyright.
Rights and permissions
About this article
Cite this article
Schramm, R.E., Reed, R.P. Stacking fault energies of fcc fe-Ni alloys by x-ray diffraction line profile analysis. Metall Trans A 7, 359–363 (1976). https://doi.org/10.1007/BF02642831
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02642831