Abstract
The dissolution behavior of type 304 stainless steel was studied in typical pickling environments in an effort to reduce the unnecessary loss of the critical metals nickel and chromium during the pickling process. Dissolution rates were determined for a 90-minute exposure to HNO3/HF solutions ranging from 0.8 M to 3.5 M HNO3 and 0.5 M to 2.6 M HF at 30°, 50°, 70°, and 90 °C and containing 0 to 0.21 M dissolved Fe, Cr, or Ni. Dissolution rates increased as a function of increasing HNO3 concentration from 0.4 M to 1.5 M HNO3, decreased at higher HNO3 concentrations, and increased with increasing HF concentration. Experiments to determine the effect of temperature on the dissolution reaction gave a lower activation energy for solutions with higher HNO3 concentrations. The dissolved Fe and Cr decreased the dissolution rate of 304 stainless steel, while dissolved Ni had essentially no effect. The Auger electron spectroscopy (AES) and X-ray photoelectron spectroscopy (XPS) studies of films resulting from exposure to several HNO3/HF solutions indicated that the fluoride did not penetrate the thin nonprotective films but remained on the outer surface of the film. The scanning Auger microscopy (SAM) studies indicated that the fluoride was uniformly distributed over the surface. Both the dissolution and surface studies are consistent with a dissolution process which is controlled by reactions occurring either in solution or at the film-solution interface.
Similar content being viewed by others
References
M. W. Wilding and B. E. Paige: Allied Chemical Corp., ICP-1107, 1976, 56 pp.
H. S. Cole: Allied Chemical Corp., ICP-1036, 1974, 42 pp.
R. D. LeBlanc:Wire Journal, 1975, vol. 8, no. 7, pp. 81–86.
C. C. Seastrom:Corrosion, 1964, vol. 20, no. 6, pp. 179t-83t.
L. E. Davis, N. C. MacDonald, P. W. Palmberg, G. E. Riach, and R. E. Weber:Handbook of Auger Electron Spectroscopy, Perkin- Elmer Corp., Eden Prairie, MN, 1972, pp. 5–15.
R. H. J. Gerke and D. Lewis: Livermore Research Laboratory. AECD- 3702, 1954, 11 pp.
W. L. Walker: General Electric, HW-46369, 1956, 5 pp.
V. S. Muralidharan and K. S. Rajagopalan:Corrosion Science, 1979, vol. 19, pp. 199–207.
B. J. Alexander and R. T. Foley:Corrosion, 1975, vol. 31, no. 4, pp. 148–49.
D. Altura and K. Nobe:Corrosion, 1973, vol. 29, no. 11, pp. 433–34.
A. C. Makrides and N. Hackerman:J. Electrochem. Soc, 1958, vol. 105, pp. 156–62.
O. L. Riggs:Corrosion, 1968, vol. 24, no. 5, pp. 125–26.
B. S. Covino, J. P. Carter, and S. D. Cramer:Corrosion, 1980, vol. 36, no. 10, pp. 554–58.
T. Ishikawa and G. Okamoto:Electrochimica Acta, 1964, vol. 9, pp. 1259–68.
K. Asami and K. Hashimoto:Corrosion Sci., 1979, vol. 19, p. 1007.
B. Lochel and H.H. Strehblow:Electrochimica Acta, 1983, vol. 28, no. 4, pp. 565–71.
R. M. Smith and A. E. Martell:Critical Stability Constants, Vol. 4—Inorganic Complexes, Plenum Press, New York, NY, 1976, pp. 96–103.
M. Pourbaix:Atlas of Electrochemical Equilibria in Aqueous Solutions, Pergamon Press, New York, NY, 1966, p. 587.
V. P. Razygraev and E. Yu. Ponomareva:Protection of Metals, 1978, vol. 14, no. 1, pp. 378–79.
J. W. Mellon:A Comprehensive Treatise on Inorganic and Theoretical Chemistry, Longmans, Green and Co., New York, NY, 1931, vol. VIII, pp. 417–598.
Ibid., 1927, vol. II, p. 12.
B. P. Lochel and H. H. Strehblow:J. Electrochem. Soc, 1984, vol. 131, p. 713.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Covino, B.S., Scalera, J.V., Driscoll, T.J. et al. Dissolution behavior of 304 stainless steel in HNO3/HF mixtures. Metall Trans A 17, 137–149 (1986). https://doi.org/10.1007/BF02644450
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02644450