Abstract
Soil pollution is one of the most dangerous sorts of environmental pollutions because of waste materials, fossil fuels, etc. Unfortunately in developing countries, there are very few arrangements to prevent soil pollution due to the fossil fuels and to improve polluted soil. In this research, influences of gas oil on properties of Kalmand protected area’s sandy soil near Yazd, Iran, were studied. It was found that gas oil constituted 5.25% of soil weight in the refueling station in the region. Therefore, cleaning and strengthening of the soil by adding cement rather than expensive and complicated methods were the most important goals of this research. First, the influence of gas oil on soil properties was studied, and to improve the soil, different percentages of ordinary portland cement were added to the polluted sand to study the improved soil properties using laboratory tests. It was found that unconfined compressive strength, cohesion, and angle of internal friction of sample with 16% cement and 8% gas oil after 28 days of curing were higher than those of the specimen of 6% cement and 14% gas oil, at 4.6, 5.4, and 1.3 times, respectively. Moreover, based on falling head tests it was observed that permeability of the stabilized specimens decreased substantially. From SEM tests, fewer voids were observed in the stabilized samples, which led to less pollutant penetration into the soil. According to EDX, although dangerous elements in the contaminated specimen made up 3.99% of the specimen total weight, addition of cement introduced considerable amounts of elements that are vital for pozzolanic reactions. Therefore, it can be concluded that addition of cement to the gas oil-polluted soil not only can improve geotechnical properties of the soil and reduce its permeability, but also is very efficient for environmental issues.
Similar content being viewed by others
References
Al-Rawas, A., Hassan, H. F., Taha, R., Hago, A., Al-Shandoudi, B., & Al-Suleimani, Y. (2005). Stabilization of oil-contaminated soils using cement and cement by-pass dust. Management of Environmental Quality: An International Journal, 16(6), 670–680. doi:10.1108/14777830510623736.
Al-Sanad, H., & Ismael, N. (1997). Aging effects on oil-contaminated Kuwaiti sand. Journal of Geotechnical and Geoenvironmental Engineering, 123(3), 290–293. doi:10.1061/(ASCE)1090-0241(1997)123:3(290).
American Society of Testing Materials (ASTM). (2000). Annual book of ASTM standards, Section four: Construction (Vol. 04.08). West Conshohocken: ASTM.
An, J., Kim, J. Y., Kim, K. W., Park, J. Y., Lee, J. S., & Jang, M. (2011). Natural attenuation of arsenic in the wetland system around abandoned mining area. Environmental Geochemistry and Health, 33, 71. doi:10.1007/s10653-010-9361-3.
Chew, S. J., & Lee, C. Y. (2010). Simple shear behaviour of palm biodiesel contaminated soil. ARPN Journal of Engineering and Applied Sciences, 5(12), 6–9.
Ganjidoust, H., Hassan, A., & Ashkiki, A. R. (2009). Cement base solidification/stabilization of heavy metal contaminated soils with objective of achieving high compressive strength of the final matrix. Transaction A: Civil Engineering, 16, 107–115.
Head, K. H. (2006). Manual of soil laboratory testing (3rd ed.). London: Whittles Publishing.
Hunt, A. (2016). Relative bioaccessibility of Pb-based paint in soil. Environmental Geochemistry and Health, 38, 1037. doi:10.1007/s10653-015-9789-6.
Khamehchiyan, M., Charkhabi, A. H., & Tajik, M. (2007). Effects of crude oil contamination on geotechnical properties of clayey and sandy soils. Journal of Engineering Geology, 89, 220–229. doi:10.1016/j.enggeo.2006.10.009.
Lavan gasoil specification 500 PPM. (2015). National Iranian Oil Company International Affairs. http://www.nioc-intl.ir/WebSiteEn/Pages/PetroleumSpec.aspx.
Ling, S. Y., & Yong, L. C. (2013). Behaviour of palm biodiesel contaminated sand-concrete interface. International Journal of Engineering and Applied Sciences,. doi:10.6088/ijcser.201203013022.
Meegoda, N., & Ratnaweera, P. (1994). Compressibility of contaminated fine-grained soils. Geotechnical Testing Journal, 17(1), 101–112. doi:10.1520/GTJ10078J.
Moon, D. H., Park, J. W., Cheong, K. H., Hyun, S., Koutsospyros, A., Park, J. H., et al. (2013). Stabilization of lead and copper contaminated firing range soil using calcined oyster shells and fly ash. Environmental Geochemistry and Health, 35, 705–714. doi:10.1007/s10653-013-9528-9.
Moore, C. A., & Mitchell, J. K. (1974). Electromagnetic forces and soil strength. Geotechnique, 24(4), 627–640. doi:10.1680/geot.1974.24.4.627.
Mulongoy, K. J., & Gidda, S. B. (2008). The value of nature: ecological, economic, cultural and social benefits of protected areas. Montreal: Secretariat of the Convention on Biological Diversity.
Niemeier, D., Bai, S., & Handy, S. (2011). The impact of residential growth patterns on vehicle travel and pollutant emissions. The Journal of Transport and Land Use, 4(3), 65–80.
Ochepo, J., Ibrahim, M., & Joseph, V. (2013). Effect of oil contamination on lime and cement stabilized laterite soil. Asian Journal of Engineering and Technology, 1(5), 207–216.
Parmelee, R. W., Phillips, C. T., Checkai, R. T., & Bohlen, P. J. (1997). Determining the effects of pollutants on soil faunal communities and trophic structure using a refined microcosm system. Environmental Toxicology and Chemistry, 16, 1212–1217. doi:10.1002/etc.5620160616.
Puri, V. K. (2000). Geotechnical aspects of oil-contaminated sands. Soil and Sediment Contamination, 9(4), 359–374. doi:10.1080/10588330091134301.
Rahgozar, M. A., & Saberian, M. (2015). Physical and chemical properties of two Iranian peat types. Mires and Peat, 16, 1–17.
Rahgozar, M., & Saberian, M. (2016). Geotechnical properties of peat soil stabilised with shredded waste tyre chips. Mires and Peat, 18(03), 1–12.
Rodríguez-Barroso, M. R., Ramírez-del Solar, M., Blanco, E., Quiroga, J. M., & García-Morales, J. L. (2006). Thermal analysis in the evaluation of sediment pollution. Environmental Technology, 27, 1001–1009.
Rodríguez-Barroso, M. R., Ramírez-del Solar, M., Blanco, E., Quiroga, J. M., & García-Morales, J. L. (2008). Qualitative estimation of heavy metals in marine sediment using thermal analysis. Soil & Sediment Contamination: An International Journal, 17, 107–120.
Rodríguez-Barroso, M. R., Ramírez-del Solar, M., Blanco, E., Quiroga, J. M., & García-Morales, J. L. (2009). Thermal gravimetry analysis assessed as an alternative method for characterization of sediment contamination. Environmental and Engineering Science, 26, 279–288.
Saberian, M., & Rahgozar, M. A. (2016). Geotechnical properties of peat soil stabilised with shredded waste tyre chips in combination with gypsum, lime or cement. Mires and Peat, 18(16), 1–16. doi:10.19189/MaP.2015.OMB.211.
Shin, E. C., & Das, B. M. (2001). Bearing capacity of unsaturated oil-contaminated sand. International Journal of Offshore and Polar Engineering, 11(3).
Shin, E., Lee, J., & Das, B. (1999). Bearing capacity of a model scale footing on crude oil-contaminated sand. Geotechnical and Geological Engineering, 17(2), 123–132. doi:10.1023/A:1016078420298.
Stagnitti, F., Parlange, J.Y., Steenhuis, T.S., Barry, D.A., Li, L., & Lockington, A. (2006). Mathematical equations of the spread of pollution in soils. Hydrological System Modeling, Encyclopedia of Life Support Systems, 2.
TEEB (2010). In P. Kumar (Ed.), The economics of ecosystems and biodiversity ecological and economic foundations. London, Washington: Earthscan.
TESCAN USA Inc., 765 Commonwealth Drive, Suite 101, Warrendale, PA 15086.
USEPA Method 1311 (2003). Toxicity characteristic leaching procedure, test method for evaluation of solid wastes, physical, chemical methods, SW846. Adapted from http://www.epa.gov/.
Acknowledgements
Laboratory experiments of this research were done in the form of specialize projects by Mr. Ali Nassiri entitled “the influence of oil pollutions in fueling stations on mechanical properties of soil” and Farzad Zare under title of “the influence of oil pollutions on soil strength parameters and its stabilization with cement” in Faculty of Civil Engineering, University of Yazd-Iran under supervision of the second author of this article hereby acknowledge for their efforts. We also appreciate efforts of Dr. Mohammad Ali Rahogzar and thank Geotechnical laboratories of Department of Civil Engineering, Yazd University, Iran and Department of Civil Engineering, University of Isfahan, Iran. Moreover, efforts of Isfahan Science and Technology Town are also appreciated.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Saberian, M., Khabiri, M.M. Effect of oil pollution on function of sandy soils in protected deserts and investigation of their improvement guidelines (case study: Kalmand area, Iran). Environ Geochem Health 40, 243–254 (2018). https://doi.org/10.1007/s10653-016-9897-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10653-016-9897-y