Static and Dynamic Slider Air-Bearing Behavior in Heat-Assisted Magnetic Recording Under Thermal Flying Height Control and Laser System-Induced Protrusion

The air bearing’s response to regions of elevated temperature on its bounding surfaces (the slider and disk) may be an important consideration in the head–disk interface design of heat-assisted magnetic recording (HAMR) systems. We implement the general non-isothermal molecular gas lubrication equation into an iterative static solver and dynamic air-bearing solver to evaluate the effect of localized heating of the air-bearing surface (ABS) due to the near-field transducer (NFT). The heat-dissipating components in our simplified HAMR design are the NFT, laser diode, and thermal flying height control (TFC) heater. We investigate the effect of each HAMR slider component on ABS temperature and thermal deformation and the slider’s flying height. The NFT induces a localized thermal spot and protrusion on the larger TFC bulge, and it is the location of maximum temperature. This ABS temperature profile alters the air-bearing pressure distribution, increasing the pressure at the hot NFT location compared with predictions of an isothermal air-bearing solver, so that the center of the pressure acting on the ABS is slightly closer to the trailing edge, thereby decreasing the pitch angle and increasing the minimum flying height. Other researchers have shown that the NFT’s thermal response time may be much faster than its protrusion response time (Xu et al. in IEEE Trans Magn 48:3280–3283, 2012). The slider’s dynamic response to a time-varying NFT thermal spot on the ABS while the combined TFC and NFT induced thermal protrusion remains constant is investigated with our dynamic air-bearing solver. We simulate the slider’s step response to a suddenly applied ABS temperature profile and a pulsed temperature profile that represents laser-on over data zones and laser-off over servo zones. The sudden (step) or rapid (pulse) increase in ABS temperature induces a sudden or rapid increase in pressure at the NFT location, thereby exciting the air bearing’s first pitch mode. For the slider design and simulation conditions used here, the result of the pitch mode excitation is to alter the position of the center of pressure in the slider’s length direction, thereby changing the pitch moment. In response, the pitch angle and minimum flying height change. The step response decays after approximately 0.15 ms. Because the laser duty cycle is much shorter than this response time, a periodic disturbance is predicted for the center of pressure coordinate, pitch angle, and minimum flying height. The peak-to-peak minimum flying height modulations are relatively small (only up to 0.126 nm); more significantly, the time-averaged minimum flying height increases 0.5 nm for the NFT that reached 208 °C compared to simulations of the isothermal ABS at ambient temperature.