Abstract
The design and development of flapping wing micro air vehicles is an active research area. In this study, design of a wing flapping mechanism is presented based upon continuously variable transmission systems. This mechanism is capable of generating flapping modes, with different and adjustable frequencies for the two wings of a flapping wing micro air vehicle. There is a provision for introducing or correcting asymmetry in flapping frequency of the two wings while keeping the amplitude fixed. Continuously varying transmission utilizing friction is used to achieve a linear change in asymmetry. The sensitivity of the frequency change mechanism can be tuned to reduce the motion and power requirements. A shift in the location of the center of gravity also occurs simultaneously assisting in roll motion control. The simulation of this dynamic system shows that different flapping frequencies for two wings of a flapping wing micro air vehicle have been achieved. A remarkable feature of this mechanism is the provision of varying the flapping frequency for both the wings with a single actuator during flight which not only reduces the weight of the mechanism but also the power requirements. A prototype has been realized to verify the functionality of this new design concept. Computer codes and commercial software’s were used to simulate kinematic and dynamic results. An aerodynamic analysis of wing profile and parametric study of link lengths has been done. Experimental values for power requirements using the prototype developed were compared with those obtained from analysis based on computer software. Results for the kinematic and dynamic simulations and experimental setup for the mechanism are presented.
Similar content being viewed by others
References
Baskar V, Muniappan A (2003) Development of flapping mechanism for micro air vehicle (mav). In: International conference on mechanical engineering, pp 26–28
Carlson DC, Cutler M, Thomson SL, Christopher A, Mattson CA, Colton MB, Harston SP (2009) Experiment-based optimization of flapping wing kinematics. In: 47th AIAA Aerospace Sciences Meeting. The New Horizons Forum and Aerospace Exposition, Orlando, Florida
De Croon GC, De Clercq KM, Ruijsink R, Remes B, De Wagter C (2009) Design, aerodynamics, and vision-based control of the DelFly. Int J Micro Air Veh 1(2):71–97. doi:10.1260/175682909789498288
Dickinson MH, Lehmann FO, Sane SP (1999) Wing rotation and the aerodynamic basis of insect flight. Science (New York, N.Y.) 284(5422):1954–1960. doi:10.1126/science.284.5422.1954
DiLeo C, Deng X (2007). Experimental test bed and prototype development for a dragonfly-inspired robot. In: IEEE/RSJ international conference on intelligent robots and systems, San Diego, California, USA, pp 1594–1599
Ellington CP, van den Berg C, Willmott AP, Thomas ALR (1996) Leading-edge vortices in insect flight. Nature 384:626–630
Hirotaka Sato CWB (2009) Remote radio control of insect flight. Front Integr Neurosci 3:24
Isaac K, Colozza A, Rolwes J (2006) Force measurements on a flapping and pitching wing at low Reynolds numbers. In: 44th AIAA aerospace sciences, pp 1–14. doi:10.2514/6.2006-450
Jadhav G (2007) The development of a MIniature flexible flapping wing mechanism for use in a robotic air vehicle. MSME Thesis, Georgia Tech. Retrieved from https://smartech.gatech.edu/handle/1853/14594
Johansson LC, Wolf M, Winter Y (2007) Bat flight generates complex aerodynamic tracks, vol 316
Lai W, Yan J, Motamed M, Green S (2005) Force measurements on a scaled mechanical model of dragonfly in forward flight. In: International conference on advanced robotics, pp 595–600
Liu L, Fang Z, He Z (2008) Optimization design of flapping mechanism and wings for flapping-wing MAVs. In: Proceedings of the first international conference, ICIRA 2008, Wuhan, China, Part I, pp 245–255. Springer, New York. doi:10.1007/978-3-540-88513-9-27
Madangopal R, Khan ZA, Agrawal SK (2006) Energetics-based design of small flapping-wing micro air vehicles. IEEE/ASME Trans Mechatron 11(4):433–438. doi:10.1109/TMECH.2006.878525
Malolan V, Dineshkumar M, Baskar V (2004) Design and development of flapping wing micro air vehicle. In: 42nd AIAA aerospace sciences meeting and exhibit, Reno, Nevada
McIntosh SH, Agrawal SK, Khan Z (2006) Design of a mechanism for biaxial rotation of a wing for a hovering vehicle. Proc First IEEE/RAS-EMBS Int Conf Biomed Robot Biomechatron 11(2):145–153. doi:10.1109/BIOROB.2006.1639050
McMichael JM, Francis MS (1997) Micro air vehicles: toward a new dimension in flight. DARPA, USA
Naef M (2009) Development of a flapping wing mechanism
Pornsin-Sirirak TN, Lee SW, Nassef H, Grasmeyer J, Tai YC, Ho CM, Keennon M (2000) MEMS wing technology for a battery-powered ornithopter. In: Proceedings IEEE thirteenth annual international conference on micro electro mechanical systems (Cat. No. 00CH36308), vol 043, pp 799–804
Rich D (2007) Hummingbird-inspired wing drive mechanism
Smith M (1995) The effects of flexibility on the aerodynamics of moth wings-Towards the development of flapping-wing technology. In: 33rd Aerospace sciences meeting and exhibit, aerospace sciences meetings. doi:10.2514/6.1995-743
Srygley RB, Thomas ALR (2002) Unconventional lift-generating mechanisms in free-flying butterflies. Nature 420:660–664. doi:10.1038/nature01223
Sun M (2002) Unsteady lift mechanisms in insect flight. Adv Mech 32(3):425–434
Sun Y, Nelson BJ (2007) MEMS capacitive force sensors for cellular and flight biomechanics. Biomed Mater 2(1):S16–S22. doi:10.1088/1748-6041/2/1/S03
Takahashi H, Matsumoto K, Shimoyama I (2010) Measurement of differential pressure on a butterfly wing. In: Proceedings of the IEEE international conference on micro electro mechanical systems (MEMS), pp 63–66. doi:10.1109/MEMSYS.2010.5442564
Tanaka H, Hoshino K, Matsumoto K, Shimoyama I (2005) Flight dynamics of a butterfly-type ornithopter. In: IEEE RSJ international conference on intelligent robots and systems
Tsang WM, Stone A, Aldworth Z, Otten D, Akinwande AI, Daniel T, Voldman J (2010) Remote control of a cyborg moth using carbon nanotube-enhanced flexible neuroprosthetic probe. In: Proceedings of the 23rd IEEE international conference on MEMS, Hong Kong, pp 39–42
van den Berg C, Ellington CP (1997) The three-dimensional leading-edge vortex of a “hovering” model hawkmoth. Philos Trans R Soc B Biol Sci 352(1351):329–340. doi:10.1098/rstb.1997.0024
Weis-Fogh T (1973) Quick estimates of flight fitness in hovering animals, including novel mechanisms for lift production. J Exp Biol 59(1):169–230
Weiss R (2007) Dragonfly or insect spy? Scientists at work on robobugs
Wootton RJ (1990) The mechanical design of insect wings. Sci Am 263(5):114–120
Zeng L, Matsumoto H, Kawachi K (1996) Two-color compensation method for measuring unsteady vertical force of an insect in a wind tunnel. Meas Sci Technol 7:515–519
Zhang G, Sun J, Chen D, Wang Y (2008) Flapping motion measurement of honeybee bilateral wings using four virtual structured-light sensors. Sensors Actuators A Phys 148(1):19–27. doi:10.1016/j.sna.2008.06.025
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Iqbal, S., Gilani, H.N., Azim, R.A. et al. Design and Analysis of a Flapping Wing Mechanism with Asymmetric Frequencies for a Micro Air Vehicle. Iran. J. Sci. Technol. Trans. Sci. 40, 75–89 (2016). https://doi.org/10.1007/s40995-016-0012-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40995-016-0012-0