Stiffness reduction of cracked solids
References (13)
- et al.
Elastic moduli of a cracked solid
Int. J. Solids Structures
(1976) Elastic moduli of a non-randomly cracked body
Int. J. Solids Structures
(1979)- et al.
Stiffness changes in unidirectional composites caused by crack systems
Mech. Materials
(1983) - et al.
Overall moduli of solids with microcracks: load-induced anisotropy
J. Mech. Phys. Solids
(1983) - et al.
Effective elastic moduli of cracked fiber composites
Wave propagation in a stratified medium
Geophysics
(1955)
Cited by (88)
Spatial attention-based dual stream transformer for concrete defect identification
2023, Measurement: Journal of the International Measurement ConfederationReview on computer vision-based crack detection and quantification methodologies for civil structures
2022, Construction and Building MaterialsCitation Excerpt :Damages are changes in the effective material properties and conditions caused by cracks, spalling, corrosion, delamination, voids etc. Concrete bridges, for instance, are susceptible to fatigue stress and cyclic loads, which often result in the formation of surface cracks, a loss of local stiffness and material discontinuities [1,2]. The type, density, width, and length of cracks on the structural surface indicate the early deterioration degree and strength capabilities [3].
The influence of hydrogen on the low cycle fatigue behavior of strain-hardened 316L stainless steel
2022, Materials Science and Engineering: ACitation Excerpt :In contrast, the formation of dislocation cells at high imposed strain levels, as shown in Fig. 12, reduces the impact of hydrogen on planar slip. It is well established that accumulation of permanent cyclic damage leads to microcracking, which decreases the stiffness of the material and induces anisotropy in the stress-strain behavior [14,61,62]. In the context of this work, the coalescence of fatigue-induced microcracks into a propagating primary crack is assumed to coincide with the observed change in the shape of the hysteresis loops during a LCF test.
Application of common-path speckle interferometer with unlimited minimal shearing amount to characterization of irregularly shaped notch
2020, NDT and E InternationalCitation Excerpt :Engineering structures are often subjected to cyclic loading and fatigue stress, which can lead to fracture. Cracks in the structures reduce the local stiffness and cause material discontinuities [1,2]. Therefore, it is very important to detect and quantify the crack damage in order to prevent possible structural failure [3].