The effect of surface roughness on the flow regime around circular cylinders

https://doi.org/10.1016/0167-6105(81)90011-8Get rights and content

Abstract

Experimental research has been carried out to study the influence of surface roughness on transitions between the subcritical, critical supercritical and postcritical regimes around isolated circular cylinders in cross-flow. The experiments were performed in an open-jet wind tunnel, which was modified to obtain satisfactorily bidimensional conditions, with Reynolds numbers ranging from ∼2.6 × 104 to ∼2.8 × 105. The cylinders were covered with different types of standard commercial emery cloth, and the estimated relative roughness varied from ∼1.0 × 10−3 to ∼12 × 10−3.

The signal from a hot-wire probe placed near the cylinder was analysed in order to ascertain the presence of vortex shedding and to obtain the Strouhal number. The mean pressure distribution around most of the cylinders were also measured, and then the drag coefficients were obtained by integration.

The boundaries between the various flow regimes as a function of the degree of roughness and of the Reynolds number were tentatively established, assuming the critical regime to be characterised by the absence of regular vortex shedding, and the postcritical one by Reynolds-number independence.

The results confirmed the striking influence of roughness on the flow regime; in particular, the critical regime can be impressively reduced, and it may even disappear in the case of highly roughened cylinders. The boundaries between the various regimes, as well as the supercritical and postcritical drag coefficients and Strouhal numbers, seem to be a function of both the size and the type of surface roughness. This is confirmation, therefore, that it is not possible to characterise the flow regime only by means of a Reynolds number based on the size of the roughness. Finally, it was demonstrated that strong supercritical and postcritical vortex shedding can take place from highly, but uniformly, roughened circular cylinders.

References (11)

  • A. Fage et al.

    The effects of turbulence and surface roughness on the drag of a circular cylinder

    Aeronaut. Res. Counc. London, Rep. and Memo., No. 1283

    (1929)
  • E. Achenbach

    Influence of surface roughness on the cross-flow around a circular cylinder

    J. Fluid Mech.

    (1971)
  • J.P. Batham

    Pressure distributions on circular cylinders at critical Reynolds numbers

    J. Fluid Mech.

    (1973)
  • E. Szechenyi

    Supercritical Reynolds number simulation for two-dimensional flow over circular cylinders

    J. Fluid Mech.

    (1975)
  • O. Güven et al.

    Surface roughness effects on the mean flow past circular cylinders

    Iowa Institute of Hydraulic Research, Tech. Rep. No. 175

    (May 1975)
There are more references available in the full text version of this article.

Cited by (74)

  • Effect of directional spreading angles on the wave hydrodynamic coefficients for vertical cylinder

    2022, Ain Shams Engineering Journal
    Citation Excerpt :

    Keulegan and Carpenter [26] have instigated a study on hydrodynamic coefficients and presented the values to the dimensionless parameter. Following with that, many researchers have expanded the study on the hydrodynamic performance of cylinders considering various parameters, e.g. the structural geometrical shapes [22,27–30], structural inclination [31–33], surface roughness [34–36], array configurations [37–39], effects of current [40–42], and the effects of water depth [43,44]. Despite these various parameters, the hydrodynamic coefficients for slender structures were still computed with the negligence of the short-crestedness characteristic.

View all citing articles on Scopus

Paper presented at the 4th Colloquium on Industrial Aerodynamics (Building Aerodynamics), Aachen, June 19–20, 1980.

View full text