Abstract
In this paper we analyze the problem of a penny-shaped hydraulic fracture propagating parallel to the free-surface of an elastic half-space. The fracture is driven by an incompressible Newtonian fluid injected at a constant rate at the center of the fracture. The flow of viscous fluid in the fracture is governed by the lubrication equation, while the crack opening and the fluid pressure are related by singular integral equations. We construct two asymptotic solutions based on the assumption that either the solid has no toughness or that the fluid has no viscosity. These asymptotic solutions must be understood as corresponding to limiting cases when the energy expended in the creation of new fracture surfaces is either small or large compared to the energy dissipated in viscous flow. It is shown that the asymptotic solutions, when properly scaled, depend only on the dimensionless parameter cal R cal, the ratio of the fracture radius over the distance from the fracture to the free-surface. The scaled solutions can thus be tabulated once and for all and the dependence of the solution on time can be retrieved for specific parameters, through simple scaling and by solving an implicit equation.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Abramowitz, M. and Stegun, I.A. (eds.) (1965). Handbook of Mathematical Functions, Dover.
Batchelor, G.K. (1967). An Introduction to Fluid Dynamics, Cambridge University Press, Cambridge, U.K.
Carbonell, R., Desroches, J. and Detournay, E. (1999). A comparison between a semi-analytical and a numerical solution of a two-dimensional hydraulic fracture. International Journal of Solids Structures 36(31-32), 4869–4888.
Carter, B.J., Desroches, J., Ingraffea, R. and Wawrzynek, P.A. (2000). Simulating fully 3D hydraulic fracturing. In: Modeling in Geomechanics, (edited by Zaman, M., Gioda, G. and Booker, J.) John Wiley & Sons, New York, NY.
Crouch, S.L. and Starfield, A.M. (1983). Boundary Element Methods in Solid Mechanics. George Allen and Unwin, London.
Desroches, J., Detournay, E., Lenoach, B., Papanastasiou, P., Pearson, J.R.A., Thiercelin, M. and Cheng, A.H.-D. (1994). The crack tip region in hydraulic fracturing. Proceedings Royal Society London A447, 39–48.
Detournay, E. (1999). Fluid and solid singularities at the tip of a fluid-driven fracture. In: Proc. IUTAM Symp. on Non-Linear Singularities in Deformation and Flow, Haifa, (edited by Durban, D. and Pearson, J.) Kluwer Academic Publishers, Dordrecht, 27–42.
Detournay, E. (2002). Propagation regimes of fluid-driven fractures in impermeable rocks. Int. J. Geomechanics (in press).
Detournay, E. and Zhang, X. (2002). Axisymmetric singular solutions for bi-material elastic space. J. Elasticity (in preparation).
Eason, G., Noble, B. and Sneddon, I.N. (1955, April). On certain integrals of Lipschitz-Hankel type involving products of Bessel functions. Phil. Trans. Roy. Soc. London A247, 529–551.
Economides, M.J. and Nolte, K.G. (eds.) (2000). Reservoir Stimulation, 3rd ed., John Wiley & Sons, Chichester, U.K.
Erdogan, F., Gupta, G.D. and Cook, T.S. (1973). Numerical Solution of Singular Integral Equations. In: Mechanics of Fracture, Vol. 1, Chapter 7, Noordhoff International Publishers, Leiden, 368–425.
Garagash D.I. (2001). Time-dependent regimes of hydraulic fracture propagation. In: Book of Abstracts, Hydraulic Fracturing Workshop Held in Conjunction with the 38th U.S. Rock Mechanics Conference, Washington DC, July 2001, (edited by Jeffrey, R.G., Detournay, E. and Ghassemi, A.), available from www.petroleum.csiro.au.
Garagash, D.I. and Detournay, E. (2000). The tip region of a fluid-driven fracture in an elastic medium. ASME J. Appl. Mech. 67, 183–192.
Geertsma, J. and Haafkens, R. (1979). A comparison of the theories for predicting width and extent of vertical hydraulically induced fractures. ASME J. Energy Res. Tech. 101, 8–19.
Gidley, J.L., Holditch, A.A., Nierode, D.E. and Veatch, R.W. (1989). Recent Advances in Hydraulic Fracturing. In: SPE Monograph Series, Vol. 12, Richardson TX: Society of Petroleum Engineers.
Hills, D., Kelly, P., Dai, E. and Korsunsky, A. (1996). Solution of Crack Problems. The Distributed Dislocation Technique. In: Solid Mechanics and Its Application, Vol. 44, Kluwer Academic Publishers, Dordrecht.
Jeffrey, R.G. and Mills, K.W. (2000). Hydraulic Fracturing Applied to Inducing Longwall Coal Mine Goaf Falls. In: Pacific Rocks 2000, Balkema, Rotterdam, 423–430.
Korsunsky, A.M. (1994). The Solution of Axisymmetric Crack Problems in Inhomogeneous Media. Ph.D. thesis, Oxford University.
Lister, J.R. (1990). Buoyancy-driven fluid fracture: The effects of material toughness and of low-viscosity precursors. J. Fluid Mech. 210, 263–280.
Peirce, A.P. and Siebrits, E. (2001). The Scaled Flexibility Matrix Method for the efficient solution of boundary value problems in 2D and 3D layered elastic media. Computer Meth. Appl. Mech. Eng. 190, 5935–5956.
Pollard, D.D. and Hozlhausen, G. (1979). On the mechanical interaction between a fluid-filled fracture and the earth's surface. Tectonophysics 53, 27–57.
Savitski, A.A. (2000). Propagation of a Penny-Shaped Hydraulic Fracture in an Impermeable Rock. Ph.D. thesis, University of Minnesota, Minneapolis.
Savitski, A.A. and Detournay (2001). Similarity solution of a penny-shaped fluid-driven fracture in a zerotoughness linear elastic solid. C.R. Acad. Sci. Paris IIb 255–262.
Savitski, A.A. and Detournay, E. (2002). Propagation of a fluid-driven penny-shaped fracture in an impermeable rock: Asymptotic solutions. Int. J. Solids Structures (submitted).
Siebrits, E. and Peirce, A.P. (2002). An efficient multi-layer planar 3D fracture growth algorithm using a fixed mesh approach. Int. J. Numer. Meth. Engng. 110, 205–239.
Sneddon, I. and Lowengrub, M. (1969). Crack Problems in the Classical Theory of Elasticity. John Wiley & sons, New York, NY.
Spence, D. and Turcotte, D. (1985). Magma-driven propagation crack. J. Geophys. Res. 90, 575–580.
Spence, D.A. and Sharp, P.W. (1985). Self-similar solution for elastohydrodynamic cavity flow. Proc. Roy. Soc. London A400, 289–313.
Srivastava, K.N. and Singh, K. (1969). The effect of penny-shaped crack on the distribution of stress in a semiinfinite solid. Int. J. Engng. Sci. 7, 469–490.
van As, A. and Jeffrey, R.G. (2000). Caving Induced by Hydraulic Fracturing at Northparkes Mines. In: Pacific Rocks 2000, Balkema, Rotterdam, 353–360.
Wang, G., Dusseault, M.B., Pindera, J.T. and Rothenburg, L. (1994). Influence of sub-surface fractures on surface deformation of an elastic half-space. Int. J. Numer. Anal. Methods Geomech. 18, 287–303.
Wang, J.J. and Clifton, R.J. (1990). Numerical Modeling of Hydraulic Fracturing in Layered Formations with Multiple Elastic Moduli. In: Rock Mechanics Contributions and Challenges, Balkema, Rotterdam, 303–310.
Young, C. (1999). Controlled-foam injection for hard rock excavation. In: Rock Mechanics for Industry, Proceedings of 37th U.S. Rock Mechanics Symposium, Vail, Colorado, Vol. 1, Balkema, Rotterdam, 115–122.
Zhang, X., Jeffrey, R.G. and Detournay, E. (2001). Numerical simulation of 2d crack problems using DDM. In: Book of Abstracts, Hydraulic Fracturing Workshop Held in Conjunction with the 38th U.S. Rock Mechanics Conference, Washington, DC, July 2001 (edited by Jeffrey, R.G., Detournay, E. and Ghassemi), available from www.petroleum.csiro.au.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Zhang, X., Detournay, E. & Jeffrey, R. Propagation of a penny-shaped hydraulic fracture parallel to the free-surface of an elastic half-space. International Journal of Fracture 115, 125–158 (2002). https://doi.org/10.1023/A:1016345906315
Issue Date:
DOI: https://doi.org/10.1023/A:1016345906315