Issue 69, 2014

Performance improvement in Cd-free Cu(In,Ga)Se2 solar cells by modifying the electronic structure of the ZnMgO buffer layer

Abstract

ZnMgO thin film is a potential buffer layer in Cu(In,Ga)Se2 (CIGS) solar cells. ZnMgO film can be uniformly deposited, and the composition of Mg can be precisely controlled by the atomic layer deposition process. The conduction band offset at the ZnMgO/CIGS interface can be reduced by increasing the Mg content in the ZnMgO buffer. The ZnMgO buffer layer with 20% Mg content has shown the best cell efficiency in the AZO/i-ZnO/ZnMgO/CIGS structure. In this study, with the removal of i-ZnO from the structure, the cell efficiency was improved from 13.9 to 15.2% due to a decrease in the series resistance and an increase in the shunt resistance. Then, the 40 nm thick Zn0.8Mg0.2O buffer layer was modified to a Zn0.9Mg0.1O (20 nm)/Zn0.8Mg0.2O (20 nm) bilayer, in which the thickness of the Zn0.8Mg0.2O layer was reduced while the total thickness was maintained to minimize plasma damage from the subsequent AZO deposition by sputtering. With the bilayer buffer, the efficiency of the CIGS solar cell was further increased from 15.2 to 16.4%. In particular, the open circuit voltage and fill factor were significantly improved. Fewer deep level states in the Zn0.9Mg0.1O/Zn0.8Mg0.2O bilayer compared to a single Zn0.8Mg0.2O layer may be responsible for the improved performance.

Graphical abstract: Performance improvement in Cd-free Cu(In,Ga)Se2 solar cells by modifying the electronic structure of the ZnMgO buffer layer

Article information

Article type
Paper
Submitted
29 Jul 2014
Accepted
07 Aug 2014
First published
07 Aug 2014

RSC Adv., 2014,4, 36784-36790

Performance improvement in Cd-free Cu(In,Ga)Se2 solar cells by modifying the electronic structure of the ZnMgO buffer layer

C. Lee, S. Kim, Y. Shin, B. G. Park, B. T. Ahn and H. Kwon, RSC Adv., 2014, 4, 36784 DOI: 10.1039/C4RA07776H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements