Assessment of the positioning performance of an industrial robot

The purpose of this paper is to investigate the use of a laser tracker, a laser interferometer system and a telescopic ballbar for assessing the positioning performance of a six‐axis industrial serial robot. The paper also aims to illustrate the limitations of these three metrology instruments for the assessment of robot positioning performance and to demonstrate the inadequacy of simplistic performance tests.

Specific test methods in the case of the laser interferometer system and the telescopic ballbar are proposed. Measurements are analyzed in accordance to the ISO 9283 norm.

It is found that, in static conditions and after a relatively short warm‐up, the unidirectional position repeatability of the non‐calibrated industrial robot under study (an ABB IRB 1600) is better than 37 μm, the unidirectional orientation repeatability is at worst 87 μrad, the linear position accuracy is better than 650 μm, and the rotation accuracy is at worst 2.8 mrad (mainly because of the sixth robot axis). It was also found that the dynamic (radial) errors due to vibrations can be up to approximately ±250 μm along a small circular path at TCP speed of 700 mm/s.

It is pointed out that the use of a laser tracker (or any other large range portable 3D measurement system) is questionable for assessing – let alone analyzing in depth – the unidirectional position repeatability of some of today's industrial robots. It is also demonstrated that the laser interferometer system can be used for measuring linear errors along a linear path of motion as well as angular errors about axes orthogonal to the path of motion. Finally, it is shown that the telescopic ballbar is an excellent, comparably low‐cost, high‐precision tool for assessing the static and dynamic positioning performance of industrial robots and its use in robotics should be further developed.

This work is the first to detail the use of three metrology equipments for assessing the positioning performance of an industrial robot. Experimental results are presented and discussed. Some guidelines for optimizing the positioning performance of an industrial robot are provided.