Skip to main content
SpringerLink
Log in

Heat transfer and critical heat flux on a modified surface during boiling under conditions of natural convection

  • Published:
Thermophysics and Aeromechanics Aims and scope

Abstract

Heat transfer and critical heat flux on flat rectangular (16 × 24 mm) heat-releasing surfaces (HS) made of aluminum alloy D16 and modified by microarc oxidation (MAO) were investigated. Two types of coatings made using different electrolytes were studied: KOH and phosphates. Coatings had good adhesion to the HS and high dielectric strength. The thickness of coatings was 20 and 7 µm, respectively. The studies were carried out using freon R21 under conditions of natural convection with horizontal orientation of the HS. For comparison, measurements were carried out on identical test sections without a modifying coating: the first section was polished; the second one was ground with a roughness of 20 µm. It was shown that the heat transfer intensity on the modified HS was not lower than that on the ground HS with a roughness of 20 µm, and it was almost twice as high as that on the polished HS. The values of the critical heat flux on the studied surfaces were almost the same. The use of these types of coatings provides electrical insulation of the heat-releasing element without compromising the efficiency of heat removal.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. H.M. Kurihara and J.E. Myers, The effects of superheat and surface roughness on boiling coefficients, AIChE J., 1960, Vol. 6, Iss. 1, P. 83–91.

    Article  Google Scholar 

  2. P.J. Berenson, Experiments on pool-boiling heat transfer, Inter. J. Heat Mass Transfer, 1962, Vol. 5, Iss. 10, P. 985–999.

    Article  Google Scholar 

  3. G.N. Danilova and V.K. Belskiy, Investigation of heat transfer during boiling of freons-113 and 12 on tubes of different roughness, Kholodilnaya Tekhnika, 1965, No. 4, P. 24–28.

  4. I.I. Gogonin, The effect of artificial vaporization centers on heat exchange during boiling of the film irrigating a bundle of horizontal finned pipes, Thermophysics and Aeromechanics, 2021, Vol. 28, No. 5, P. 697–702.

    Article  ADS  Google Scholar 

  5. D.E. Kim, D.I. Yu, D.W. Jerng, M.H. Kim, and H.S. Ahn, Review of boiling heat transfer enhancement on micro/nanostructured surfaces, Experimental Thermal and Fluid Sci., 2015, Vol. 66, P. 173–196.

    Article  Google Scholar 

  6. I.V. Suminov, A.V. Epelfeld, V.B. Lyudin, B.L. Krit, and A.M. Borisov, Microarc Oxidation (Theory, Technology, and Equipment), Ecomet, Moscow, 2005.

    Google Scholar 

  7. N.V. Vasiliev, A.Yu. Varaksin, Yu.A. Zeigarnik, K.A. Khodakov, and A.V. Epelfel’d, Characteristics of sub-cooled water boiling on structured surfaces, High Temperature, 2017, Vol. 55, No. 6, P. 880–886.

    Article  Google Scholar 

  8. A.E. Mikheev, T.V. Trushkina, A.V. Girn, D.V. Ravodina, and S.S. Ivasev, Chemical processes in microarc oxidation, Bulletin of Sib. State Aerotech. University named after M.F. Reshetnev, 2013, No. 2, P. 212–215.

  9. T.V. Trushkina, A.E. Mikheev, A.V. Girn, R.V. Alyakretskiy, and D.V. Ravodina, Morphology and porosity of the surface of oxide coatings, Bulletin of Sib. State Aerotech. University named after M.F. Reshetnev, 2014, No. 2, P. 144–148.

  10. N.I. Pecherkin, A.N. Pavlenko, O.A. Volodin, A.I. Kataev, and I.B. Mironova, Experimental study of heat transfer enhancement in a falling film of R21 on an array of horizontal tubes with MAO coating, Inter. Commun. in Heat and Mass Transfer, 2021, Vol. 129, P. 105743–1–105743–13.

    Article  Google Scholar 

  11. V.E. Zhukov, E.Yu. Slesareva, and A.N. Pavlenko, Effect of modification of heat-release surface on heat transfer in nucleate boiling at free convection of Freon, J. Engng Thermophysics, 2021, Vol. 30, No. 1, P. 1–13.

    Article  Google Scholar 

  12. V.E. Zhukov and E.Yu. Slesareva, Evaporation front propagation over a non-isothermal surface, Thermophysics and Aeromechanics, 2020, Vol. 27, No. 6, P. 873–876.

    Article  ADS  Google Scholar 

  13. D.B. Spalding and J. Taborek, Heat Exchanger Design Handbook. I. Heat Exchanger Theory, Hemisphere Publishing Corporation, Washington, 1983.

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Kutateladze Institute of Thermophysics SB RAS, Novosibirsk, Russia

    A. N. Pavlenko, V. E. Zhukov & N. N. Mezentseva

Authors
  1. A. N. Pavlenko
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. V. E. Zhukov
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. N. N. Mezentseva
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to V. E. Zhukov.

Additional information

The research was financially supported by the project of the Ministry of Education and Science of the Russian Federation (Agreement No. 075-15-2020-770).

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Pavlenko, A.N., Zhukov, V.E. & Mezentseva, N.N. Heat transfer and critical heat flux on a modified surface during boiling under conditions of natural convection. Thermophys. Aeromech. 29, 423–426 (2022). https://doi.org/10.1134/S0869864322030106

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1134/S0869864322030106

Keywords

Search

Navigation