Abstract
In this study, hydroxyapatite (HA) based composite films were successfully syntheses on the β-type Ti29Nb13Ta4.6Zr (TNTZ). The solutionized TNTZ substrates coated with HA and HA/Titania (TiO2) bioactive composite coatings by sol-gel method under various sintering parameters related to sintering temperatures and heating ramp rates. Microstructural observations of the coatings revealed that apatite was formed on the substrates. The hardness values of the coatings increase with increasing both the sintering temperature and the TiO2 concentration in the coatings layer. However, it was found that the heating ramp rate of the sintering was not affecting the hardness values so much. Also, the hardness values of the HA/TiO2 composite coatings at all sintering temperatures were higher than only HA coated TNTZ samples due to the existence TiO2 phases in the HA matrix. Results indicating that the doping of HA with TiO2, improve the physical consistency between the coating layer and the substrates and provide a better inter-particle bonding due to the existence TiO2 phases in the HA.
Similar content being viewed by others
References
Han, J.Y., Yu, Z.T., and Zhou, L., Appl. Surf. Sci., 2008, vol. 255, p. 455.
Kim, H.-W., Koh, Y.-H., Li, L.-H., et al., Biomaterials, 2004, vol. 25, p. 2533.
Lee, S.-H., Kim, H.-W., Lee, E.-J., et al., J. Biomater. Appl., 2006, vol. 20, p. 195.
Im, K.H., Lee, S.B., Kim, K.M., and Lee, Y.K., Surf. Coat. Technol., 2007, vol. 202, p. 1135.
Enayati-Jazi, M., Solati-Hashjin, M., Nemati, A., and Bakhshi, F., Superlattices Microstruct., 2012, vol. 51, p. 877.
He, G., Hu, J., Wei, S.C., et al., Appl. Surf. Sci., 2008, vol. 255, p. 442.
Kim, H.W., Kim, H.E., Salih, V., and Knowles, J.C., J. Biomed. Mater. Res., Part B, 2005, vol. 72, p. 1.
Li, P., De Groot, K., and Kokubo, T., J. Sol-Gel Sci. Technol., 1996, vol. 7, p. 27.
Li, Z., Yang, X., Guo, H., et al., J. Nanopart. Res., 2012, vol. 14, p. 1145.
Milella, E., Cosentino, F., Licciulli, A., and Massaro, C., Biomaterials, 2001, vol. 22, p. 1425.
Ramires, P., Romito, A., Cosentino, F., and Milella, E., Biomaterials, 2001, vol. 22, p. 1467.
Morks, M.F., Mater. Lett., 2010, vol. 64, p. 1968.
Lu, Y.P., Sen Li, M., Li, S.T., et al., Biomaterials, 2004, vol. 25, p. 4393.
Ivanova, A.A., Surmenev, R.A., Surmeneva, M.A., et al., Appl. Surf. Sci., 2015, vol. 329, p. 212.
Chen, W., Liu, Y., Courtney, H.S., et al., Biomaterials, 2006, vol. 27, p. 5512.
Ding, S.-J., Biomaterials, 2003, vol. 24, p. 4233.
Araghi, A. and Hadianfard, M.J., Ceram. Int., 2015, vol. 41, p. 12668.
Kim, H.J., Jeong, Y.H., Choe, H.C., and Brantley, W.A., Thin Solid Films, 2014, vol. 572, p. 119.
Bakin, B., Koc Delice, T., Tiric, U., et al., Surf. Coat. Technol., 2015, vol. 301, p. 29.
He, D.H., Wang, P., Liu, P., et al., Surf. Coat. Technol., 2015, vol. 277, p. 203.
Qiu, D., Yang, L., Yin, Y., and Wang, A., Surf. Coat. Technol., 2011, vol. 205, p. 3280.
Wen, C., Xu, W., Hu, W., and Hodgson, P., Acta Biomater., 2007, vol. 3, p. 403.
Peltola, T., Putsi, M., Rahiala, H., et al., J. Biomed. Mater. Res., 1998, vol. 41, p. 504.
Uhlmann, D., Suratwala, T., Davidson, K., et al., J. Non-Cryst. Solids, 1997, vol. 218, p. 113.
Mavis, B. and Taş, A.C., Society, 2000, vol. 91, p. 989.
Ramesh, S., Tan, C.Y., Tolouei, R., et al., Mater. Des., 2012, vol. 34, p. 148.
Barralet, J.E., Best, S.M., and Bonfield, W., J. Mater. Sci.: Mater. Med., 2000, vol. 11, p. 719.
Herliansyah, M., Hamdi, M., Ide-Ektessabi, A., et al., Mater. Sci. Eng., C, 2009, vol. 29, p. 1674.
Muralithran, G. and Ramesh, S., Ceram. Int., 2000, vol. 26, pp. 221–230.
Roop Kumar, R. and Wang, M., Mater. Lett., 2002, vol. 55, p. 133.
Xiao, X.F., Liu, R.F., and Zheng, Y.Z., Surf. Coat. Technol., 2006, vol. 200, p. 4406.
Balamurugan, A., Balossier, G., and Kannan, S., Mater. Sci. Eng., C, 2007, vol. 27, p. 162.
Prokopiev, O. and Sevostianov, I., Mater. Sci. Eng., A, 2006, vol. 431, p. 218.
Sonmez, S., Aksakal, B., and Dikici, B., J. Sol-Gel Sci. Technol., 2012, vol. 63, p. 510.
Han, J.Y., Yu, Z.T., and Zhou, L., Appl. Surf. Sci., 2008, vol. 255, p. 455.
Montenero, A., Gnappi, G., Ferrari, F., et al., J. Mater. Sci., 2000, vol. 35, p. 2791.
Author information
Authors and Affiliations
Corresponding author
Additional information
The article is published in the original.
Rights and permissions
About this article
Cite this article
Dikici, B., Niinomi, M., Topuz, M. et al. Synthesis and Characterization of Hydroxyapatite/TiO2 Coatings on the β-Type Titanium Alloys with Different Sintering Parameters using Sol-Gel Method. Prot Met Phys Chem Surf 54, 457–462 (2018). https://doi.org/10.1134/S2070205118030255
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S2070205118030255