ISIJ International
Online ISSN : 1347-5460
Print ISSN : 0915-1559
ISSN-L : 0915-1559
Recrystallization of Lath Martensite with Bulge Nucleation and Growth Mechanism
T. TsuchiyamaY. MiyamotoS. Takaki
Author information
JOURNAL FREE ACCESS

2001 Volume 41 Issue 9 Pages 1047-1052

Details
Abstract

The recrystallization behavior of lath martensite during tempering was investigated in high-chromium martensitic steels by means of hardness testing, optical and transmission electron microscopy. The role of carbide particles on the recrystallization was also discussed in terms of the grain boundary pinning effect. The hardness of tempered specimens was plotted as a function of the tempering parameter, T(logt+20), for a low-carbon steel (Fe–9Cr–0.1C mass%) and an ultra-low carbon steel (Fe–9Cr–1Ni–0.006C mass%). The low-carbon steel exhibited gradual softening with recovery but did not undergo recrystallization. However, the ultra-low carbon steel suffered abrupt softening owing to the discontinuous recrystallization of lath martensite. Microstructural observations in the ultra-low carbon steel indicated that the recrystallization of lath martensite occurs with the 'bulge nucleation and growth (BNG) mechanism'. The possibility of recrystallization via this mechanism depends upon both the spacing of carbide particles on grain boundaries and the dislocation density of martensite. An energetic analysis on the formation of a recrystallized grain revealed the critical carbide spacing minimum required for the occurrence of recrystallization as a function of dislocation density. In the case of the low-carbon steel, carbide precipitates on grain boundaries with spacing smaller than the critical value, thus suppressing recrystallization.

Content from these authors
© The Iron and Steel Institute of Japan
Previous article Next article
feedback
Top