Milling Characteristic of Plastic Profiles Manufacturing

Ning Fan; Xiang Bo Ze; Xiu Li Fu

doi:10.4028/www.scientific.net/AMR.230-232.522

Paper Titles

Service-Oriented Sharing Architecture for Mining Area Spatial Information and Key Techniques
p.501

The Solid Modeling and Simulation for Non-Circular Gear Based on Pro/E
p.506

Mobile Phone Input Method Interface Evaluation Based on GOMS Prediction Model
p.512

Influence of Side-Insulation Film on Hybrid Process of Micro EDM and ECM for 3D Micro Structures
p.517

Milling Characteristic of Plastic Profiles Manufacturing
p.522

An Environmental Friendly Based Research on the Safety of Food Packing Materials
p.526

Lengthwise Detection of High Linearity Micromachined Gyroscope
p.529

Analysis and Structural Topology Optimization for Cross Section of Beam
p.534

Dynamic Mechanical Analysis of Automotive Gearbox Casing
p.539

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 230-232Milling Characteristic of Plastic Profiles...

Milling Characteristic of Plastic Profiles Manufacturing

Abstract:

Groove milling is an important working procedure in plastic profiles manufacturing. Rational milling parameters have great effect on machining efficiency and quality. The milling characteristic of plastic profiles is investigated by cutting experiments in the present paper. The cutting forces increase with the feed speed increase. The vibration occurs easily in transverse cutting because of the low stiffness of the plastic profiles. When the feed speed is large, the workpiece material would produce softening and daubing phenomena appears subsequently on the workpiece surface which affects machining quality. It is therefore that the milling parameters are determined by the avoidance of cutting vibration as well as daubing effect at the same time.