Three-Dimensional Shape Modeling of Diamond Abrasive Grains Measured by a Scanning Laser Microscope

[2] K. Uegami, Y. Sato, K. Katsuda and L. Wang, Effects of Crystallographic Orientation of Single Crystal Diamond Cutting Tool on Machined Surface Properties, Journal of the Society of Grinding Engineers, Vol.45, No.10, 2001, pp.480-485.

Google Scholar

[3] J. Shibata, M. Mayuzumi and T. Shimizu, Ductile-Regime Chip Formation of Glass and the Effect of the Shape on the Cutting Edge with the Intent to Produce Flow-type Chips, Transactions of the Japan Society of Mechanical Engineering(C), Vol.64, No.624, 1998, pp.4465-4471.

DOI: 10.1299/kikaic.64.4465

Google Scholar

[4] I. Inasaki, Grinding Process Simulation Based on the Wheel Topography Measurement, Annals of the CIRP, Vol.45/1/1996, pp.347-350.

DOI: 10.1016/s0007-8506(07)63077-7

Google Scholar

[5] J. Tamaki and T. Kitagawa, Evaluation of Surface Topography of Metal-Bonded Diamond Wheel Utilizing Three-Dimensional Profilometry, Int. J. Mach. Tools Manufact. Vol.35, No.10, 1995, pp.1339-1351.

DOI: 10.1016/0890-6955(95)00008-l

Google Scholar

[6] J. Tamaki, T. Iyama and Z. Libo, Behavior of Bond Tails in Ceramics Grinding with a MetalBonded Diamond Wheel, Proceedings of the International Conference on Precision Engineering, 1997, pp.291-296.

Google Scholar

[7] K. Miura, M. Okada and J. Tamaki, Three-Dimensional Measurement of Wheel Surface Topography with a Laser Beam Probe, Advances in Abrasive Technology III, 2000, pp.303-308.

Google Scholar

[8] T. Mahmoud, J. Tamaki, S.Suzuki and T. Iyama, Measurement of Three-Dimensional Shape of Abrasive Diamond Grain by Means of Laser Beam Microscope, Advances in Abrasive Technology IV, 2001, pp.387-394. Rake ridge Wedge angle � w Relative frequency Wedge angle � w 139 measurements over 50 grains � w = 112° Fig. 11 Definition and measurement result of wedge angle

DOI: 10.4028/www.scientific.net/kem.238-239.131

Google Scholar