The IF Spectrum of Fe-C-N and Fe-17%Cr-C-N Alloys Measured by the Impulse Excitation Technique

I. Jung; Bruno C. De Cooman

doi:10.4028/www.scientific.net/SSP.184.209

Paper Titles

Fatigue Behavior of Magnesium Alloy AJ91 Studied by Amplitude Dependent Damping Measurements
p.185

Ultrasonic Study of Elastic and Anelastic Properties of C/Mg-2wt.%Si Composite
p.191

Internal Friction in Extruded Aluminium Alloy
p.197

Static Strain Aging in Fe-Mn-N Alloys Investigated by Impulse Excitation Internal Friction Analysis
p.203

The IF Spectrum of Fe-C-N and Fe-17%Cr-C-N Alloys Measured by the Impulse Excitation Technique
p.209

Internal Friction and Magnetic After-Effect Study of Dislocation Dynamics in Thermally Aged Fe-1%Cu-C Alloys
p.215

Anelastic Effects on Martensitic Carbon Steels during First Stage of Tempering
p.221

Hydrogen-Dislocation Interaction in Austenitic Stainless Steel Studied with Mechanical Loss Spectroscopy
p.227

Characterization of Defects in Severely Deformed Iron by Mechanical Spectroscopy
p.233

HomeSolid State PhenomenaSolid State Phenomena Vol. 184The IF Spectrum of Fe-C-N and Fe-17%Cr-C-N Alloys...

The IF Spectrum of Fe-C-N and Fe-17%Cr-C-N Alloys Measured by the Impulse Excitation Technique

Abstract:

The temperature dependence of the dynamic Young’s modulus, E, and the damping, Q^-1, of Fe-C-N and Fe-17%Cr-C-N alloys with different C, N contents were studied in the temperature range of 25°C to 600°C by the impulse excitation internal friction technique at 1KHz. Hot rolled samples were cold rolled to a thickness of 1.2mm and recrystallization annealed at 820°C for 30sec then gas jet cooled (-50°C/sec). Samples were subsequently tensile strained 6% and 16%. A Snoek peak was observed at 120°C in the undeformed sample and a Snoek-Koster peak was observed at 400°C after deformation. In the case of the Fe-Cr-C-N alloy, a high damping background due to magneto-mechanical damping was observed in the temperature range of 25°C to 400°C. A broaden Snoek peak in FeCr was observed at 300°C. The internal friction peaks observed in this study showed the strong dependence of the amount of interstitial contents and deformation and were well correlated to previous internal friction studies measured mainly by torsion pendulum and inverted torsion pendulum.