Ausgabe 10-11/2011
Inhalt (15 Artikel)
The development of two-component micro powder injection moulding and sinter joining
- Review Paper
Andreas Ruh, Katharina Klimscha, Volker Piotter, Klaus Plewa, Hans-Joachim Ritzhaupt-Kleissl, Jürgen Fleischer
Microelectromechanical resonators for radio frequency communication applications
- Review Article
Joydeep Basu, Tarun Kanti Bhattacharyya
A new transparent Bio-MEMS for uni-axial single cell stretching
- Review Paper
R. Fior, S. Maggiolino, M. Lazzarino, O. Sbaizero
A top-down design methodology of MEMS varactor for RF applications based on a substrate-induced capacitive model
- Technical Paper
A. Bhattacharya, Subha Chakraborty, T. K. Bhattacharyya
Analysis and suppression of spurious modes of the ring shape anchored RF MEMS contour mode disk resonator
- Technical Paper
Masoud Baghelani, Habib Badri Ghavifekr, Afshin Ebrahimi
Fabrication of large-area microfluidics structures on glass by imprinting and diode-pumped solid state laser writing techniques
- Technical Paper
Qiuping Chen, Qiuling Chen, Gabriele Maccioni, Adriano Sacco, Luciano Scaltrito, Monica Ferraris, Sergio Ferrero
Comparison of etch characteristics of KOH, TMAH and EDP for bulk micromachining of silicon (110)
- Technical Paper
Shankar Dutta, Md Imran, P. Kumar, R. Pal, P. Datta, R. Chatterjee
A simple thermo-compression bonding setup for wire bonding interconnection in pressure sensor silicon chip packaging
- Technical Paper
Quan Wang, Xiaodan Yang, Yanmin Zhang, Jianning Ding
Air-coupled linear and sparse cMUT array manufactured using MUMPs process
- Technical Paper
Alberto Octavio, Richard L. O’Leary, Simon M. Whiteley, Óscar Martínez-Graullera, Carlos J. Martín-Arguedas, Luis Gómez-Ullate, Francisco Montero de Espinosa
Reduction of torque ripple and mechanical vibration of spindle motors in hard-disk drives using a sinusoidal driver
- Technical Paper
Phunlap Mekkemthong, Kittiwat Chiangchin, Surapong Suwankawin
A low cost approach for the fabrication of microwave phase shifter on laminates
- Technical Paper
Poonam Goel, K. J. Vinoy
Coupled effects of gold electroplating and electrochemical discharge machining processes on the performance improvement of a capacitive accelerometer
- Technical Paper
A. Ravi Sankar, V. Swathi Sree Bindu, S. Das
Fabrication of metallic micromirror using electroplating technology
- Technical Paper
Jia-dong Li, Ping Zhang, Yi-hui Wu, Yong-shun Liu, Ming Xuan
Innovative design of hollow polymeric microneedles for transdermal drug delivery
- Technical Paper
Marion Sausse Lhernould, A. Delchambre
