Synchronized Optimization of Injection Moulding Parameters for Higher Acceptance of Polypropylene Products

The present exploration focuses on synchronized optimization of injection moulding parameters to adjudge the suitability of the polypropylene products in view of higher acceptance. A full factorial experimental layout was framed for the moulding parameters like injection temperature, pressure and speed, all at three levels. Before launching into the market, polypropylene products need to qualify the strength test (ASTM-D638-03), density test (ASTM-D 792), and Vicat Softening Point test (ASTM-D 1525). Grey Relational Analysis (GRA) was adopted to convert the multiple objectives into a single objective. Specimens were prepared at all the parametric combinations through injection moulding in compliance with ASTM-D 638-03-TYPE-I. The above mentioned tests have been carried for every specimen and the responses were obtained. It has been observed that products manufactured at 200 °C Injection Temperature, 70 bar Injection Pressure and 80 rpm Injection speed are poised with higher level of suitability from acceptance point of view. Grey analysis reveals injection temperature is the most dictating factor followed by injection velocity and injection pressure.