Thermal-Induced Fault Weakening and Fluid Pressurization During Fluid Injection

Thermal pressurization of the trapped pore fluid is considered to be a widespread fault weakening during fluid injection in confined geological formations. Tremendous amounts of heats will be generated within the narrow shear zone during fault slip. Considering the melting of the fault gouge, the fault seal zone is adopted to construct the fluid pressurization model, thermal pressurization implemented in Comsol Multiphysics is established to illustrate the fault weaken coefficient and effective normal stress during fluid injection. The friction weakening coefficients m_T and m_F are proposed to research the performance of fault weakening during fluid injection. The results indicate that, the friction coefficients m_T and m_F both exhibit the initially decreasing and then increasing tendency, and thermal-induced fault weakening of CO₂ injection occurs earlier than that of water injection. It was found that initial pore pressure and fault sealing porosity have a negligible influence on the evolutions of friction weakening and effective normal stress. Initial normal stress and fault sealing permeability have certain obvious influences on fault weakening during CO₂ injection. Fault thickness is the primary factor influencing the friction weakening coefficient. When the fault thickness is over 1 mm, the variation of fault weakening is totally different from that when the thickness is less than 1 mm. This investigation of friction weakening during fault slip provides an effective reference for fluid injection.