An Experimental Study on Bearing Capacity of Steel Open Ended Pipe Pile with Exterior Wings Under Compression Load

The present study investigates the increasing in ultimate pile capacity and studied the soil plugging phenomenon and the incremental filing ratio for a modified type of open-ended pipe pile. The modification performed by adding steel plates as wings with special dimensions and fixed on the exterior face of the pipe pile wall at a location near the pile tip with specified dimensions. Five wings have used for each new model of pipe pile. These wings distributed in equal spacing along with the circumstances of the exterior wall of the open-ended pipe piles. The efficiency of the proposed type studied by modelling and manufacturing twelve piles (40 mm diameter, L/D = 15 and L/D = 20). Complete setup manufactured for installing and loading the piles in a constant rate of penetration. The model piles installed in poorly graded loose dry sand. The obtained results show that the proposed type has a higher ultimate bearing capacity. The percentage of increase reaches more than 50%. The development of the load capacity is due to the three effects. The first is increases of the exterior shaft friction, and the second effect creates a new end-bearing capacity under the constrained soil between the exterior wings. And the third effect is developing the end-bearing capacity under the soil plug inside open-ended pipe pile due to the first and the second effects.