Top

Metal Science and Heat Treatment

Published in:

23-01-2017

Effect of Low Additions of Y, Sm, Gd, Hf and Er on the Structure and Hardness of Alloy Al – 0.2% Zr – 0.1% Sc

Authors: A. V. Pozdnyakov, A. A. Osipenkova, D. A. Popov, S. V. Makhov, V. I. Napalkov

Published in: Metal Science and Heat Treatment | Issue 9-10/2017

Activate our intelligent search to find suitable subject content or patents.

search-config

AI-assisted search

Off

Abstract

The structure and phase composition of addition alloys based on aluminum with Hf, Er, Gd, Yand Sm and the effect of low additions of these transition metals on the structure and properties of alloy Al – 0.2% Zr – 0.1% Sc are studied. It is shown that individual introduction of Y, Sm, Er, and Gd in an amount of 0.1% each causes formation of eutectic phases Al₃Y, Al₃Sm, Al₃Er and Al₃Gd, respectively. An indirect inference is that the additions of Y, Sm, Hf, Er and Gd raise the thermal stability of the Al₃ (Sc, Zr) dispersoids after annealing at 250°C with a hold of up to 100 h; softening at 370°C starts after holding for 54 h. Maximum hardening is detected in the case of 0.1% Er and attains 50 HV after a 54-h hold at 370°C.

previous article A Study of Structural Changes in Pressed Semiproducts from Aluminum Alloy V95ochT2 in the Range of Dark Spots

next article Formation of Fine-Grained Structure and Superplasticity in Commercial Aluminum Alloy 1565ch

Dont have a licence yet? Then find out more about our products and how to get one now:

Springer Professional "Wirtschaft+Technik"

Online-Abonnement

Mit Springer Professional "Wirtschaft+Technik" erhalten Sie Zugriff auf:

über 102.000 Bücher
über 537 Zeitschriften

aus folgenden Fachgebieten:

Automobil + Motoren
Bauwesen + Immobilien
Business IT + Informatik
Elektrotechnik + Elektronik
Energie + Nachhaltigkeit
Finance + Banking
Management + Führung
Marketing + Vertrieb
Maschinenbau + Werkstoffe
Versicherung + Risiko

Jetzt Wissensvorsprung sichern!

inform now

Springer Professional "Technik"

Online-Abonnement

Mit Springer Professional "Technik" erhalten Sie Zugriff auf:

über 67.000 Bücher
über 390 Zeitschriften

aus folgenden Fachgebieten:

Automobil + Motoren
Bauwesen + Immobilien
Business IT + Informatik
Elektrotechnik + Elektronik
Energie + Nachhaltigkeit
Maschinenbau + Werkstoffe

Jetzt Wissensvorsprung sichern!

inform now

If not mentioned specially, the content of the elements is given in mass percent.

C. B. Fuller, J. L. Murray, and D. N. Seidman, “Temporal evolution of the nanostructure of Al(Sc, Zr) alloys. Part I. Chemical compositions of Al₃(Sc_{1 – x}Zr_x) precipitates,” Acta Mater., 53, 5401 – 5413 (2005).CrossRef

C. B. Fuller and D. N. Seidman, “Temporal evolution of the nanostructure of Al(Sc, Zr) alloys. Part II. Coarsening of Al₃(Sc_{1 –x}Zr_x) precipitates,” Acta Mater., 53, 5415 – 5428 (2005).CrossRef

W. Lefebvrea, F. Danoixa, H. Hallem, et al., “Precipitation kinetics of Al₃(Sc, Zr) dispersoids in aluminum,” J. Alloys Compd., 470, 107 – 110 (2009).CrossRef

A. K. Lohara, B. Mondala, D. Rafajab, et al., “Microstructural investigations of as-cast and annealed Al – Sc and Al – Sc – Zr alloys,” Mater. Charact., 60, 1387 – 1394 (2009).CrossRef

V. Ocenasek and M. Slamova, “Resistance to recrystallization due to Sc and Zr additions to Al – Mg alloys,” Mater. Charact., 47, 157 – 162 (2001).CrossRef

Gen Li, Naiqin Zhao, Tao Liu, et al., “Effect of Sc/Zr ratio on the microstructure and mechanical properties of new type of Al – Zn – Mg – Sc – Zr alloys,” Mater. Sci. Eng. A, 617, 219 – 227 (2014).CrossRef

C. B. Fuller, A. R. Krause, D. C. Dunand, and D, N. Seidman, “Microstructure and mechanical properties of a 5754 aluminum alloy modified by Sc and Zr additions,” Mater. Sci. Eng. A, 338, 8 – 16 (2002).

V. G. Davydov, T. D. Rostova, V. V. Zakharov, et al., “Scientific principles of making an alloying addition of scandium to aluminum alloys,” Mater. Sci. Eng. A, 280, 30 – 36 (2000).CrossRef

Yu. A. Filatov, V. I. Elagin, and V. V. Zakharov, “New Al –Mg – Sc alloys,” Mater. Sci. Eng. A, 280, 97 – 101 (2000).CrossRef

10.

C. Booth-Morrison, D. C. Dunand, and D. N. Seidman, “Coarsening resistance at 400°C of precipitation-strengthened Al – Zr – Sc – Er alloys,” Acta Mater., 59, 7029 – 7042 (2011).CrossRef

11.

S. P.Wen, L. Y. Gao, Y. Li, et al., “Synergetic effect of Er and Zr on the precipitation hardening of Al – Er – Zr alloy,” Scr. Mater., 65, 592 – 595 (2011).

12.

H. L. Hao, D. R. Ni, Z. Zhang, et al., “Microstructure and mechanical properties of Al – Mg – Er sheets jointed by friction stir welding,” Mater. Design, 52, 706 – 712 (2013).CrossRef

13.

Yang Dongxi, Li Xiaoyan, He Dingyong, and Huang Hui, “Effect of minor Er and Zr on microstructure and mechanical properties of Al – Mg – Mn alloy (5083) welded joints,” Mater. Sci. Eng. A, 561, 226 – 231 (2013).CrossRef

14.

Y. Zhang, H. Gao, Y. Kuai, et al., “Effects of Y additions on the precipitation and recrystallization of Al – Zr alloys,” Mater. Charact., 86, 1 – 8 (2013).CrossRef

15.

XingGuo Zhang, FeiQiang Mei, Huan Yue Zhang, et al. “Effects of Gd and Y additions on microstructure and properties of Al – Zn – Mg – Cu – Zr alloys,” Mater. Sci. Eng. A, 552, 230 – 235 (2012).

16.

C. Booth-Morrison, D. N. Seidman, and D. C. Dunand, “Effect of Er additions on ambient and high-temperature strength of precipitation-strengthened Al – Zr – Sc – Si alloys,” Acta Mater., 60, 3643 – 3654 (2012).CrossRef

17.

H. Li, Z. Gao, H. Yin, et al., “Effect of Er and Zr additions on precipitation and recrystallization of pure aluminum,” Scr. Mater., 68, 59 – 62 (2013).CrossRef

18.

L. Z. He, X. H. Li, Z. T. Liu, et al., “Effects of homogenization on microstructures and properties of a new type Al –Mg –Mn – Zr – Ti – Er alloy,” Mater. Sci. Eng. A, 527, 7510 – 7518 (2010).CrossRef

19.

N. Q. Vo, D. C. Dunand, and D. N. Seidman, “Improving aging and creep resistance in a dilute Al – Sc alloy by microalloying with Si, Zr and Er,” Acta Mater., 63, 73 – 85 (2014).CrossRef

20.

M. E. Van Dalen, D. C. Dunand, and D. N. Seidman, “Microstructural evolution and creep properties of precipitationstrengthened Al – 0.06Sc – 0.02Gd and Al – 0.06Sc – 0.02Yb (at.%) alloys,” Acta Mater., 59, 5224 – 5237 (2011).CrossRef

21.

S. P. Wen, K. Y. Gao, H. Huang, et al., “Precipitation evolution in Al – Er – Zr alloys during aging at elevated temperature,” J. Alloys Compd., 574, 92 – 97 (2013).CrossRef

22.

H. Hallem, W. Lefebvre, B. Forbord, et al., “The formation of Al₃(Sc_xZr_yHf_{1– x – y})-dispersoids in aluminum alloys,” Mater. Sci. Eng. A, 421, 154 – 160 (2006).CrossRef

23.

N. P. Lyakishev, O. A. Bannykh, L. L. Rokhlin, et al., Phase Diagrams of Binary Metallic Systems, Vol. 1 [in Russian], Mashinostroenie, Moscow (1996), 992 p.

Title: Effect of Low Additions of Y, Sm, Gd, Hf and Er on the Structure and Hardness of Alloy Al – 0.2% Zr – 0.1% Sc
Authors: A. V. Pozdnyakov
A. A. Osipenkova
D. A. Popov
S. V. Makhov
V. I. Napalkov
Publication date: 23-01-2017
Publisher: Springer US
Published in: Metal Science and Heat Treatment / Issue 9-10/2017
Print ISSN: 0026-0673
Electronic ISSN: 1573-8973
DOI: https://doi.org/10.1007/s11041-017-0050-z

Springer Professional

Abstract

Please log in to get access to your license.

Dont have a licence yet? Then find out more about our products and how to get one now:

Springer Professional "Wirtschaft+Technik"

Springer Professional "Technik"

Other articles of this Issue 9-10/2017

Strength of “Light” Ferritic and Austenitic Steels Based on the Fe – Mn – Al – C System

Formation of Multiphase Microstructure in Steel 35CrMnSi by Intercritical Annealing – Quenching – Partitioning Heat Treatment

Effect of Annealing on the Electrical Resistivity and Strengthening of Low-Alloy Alloys of the Al – Zr – Si System

Effect of the Error of Measurement of Current Harmonics on the Accuracy of Determination of Magnetic Characteristics

Effect of the Temperature of Hot Rolling on Formation of Microdiscontinuities on Nonmetallic Inclusions in Steel ShKh15SG

Modern Sparingly Alloyed Titanium Alloys: Application and Prospects

Premium Partners