Issue 6/2003
Content (20 Articles)
Precipitation of heusler phase (Ni2TiAl) from B2-TiNi in Ni-Ti-Al and Ni-Ti-Al-X (X=Hf, Zr) alloys
J. Jung, G. Ghosh, D. Isheim, G. B. Olson
On the application of the additivity rule in pearlitic transformation in low alloy steels
J. S. Ye, T. Y. Hsu, H. B. Chang
Effect of service-simulated aging on the microstructure and properties of casing casting steel (1CrMoV) vis-à-vis remnant life assessment
S. C. Bose, K. S. Reddy, G. Jaipal Reddy, Kulvir Singh, D. S. Sarma
Analysis of fracture toughness in the transition-temperature region of an Mn-Mo-Ni low-alloy steel
Sangho Kim, Byoungchul Hwang, Sunghak Lee, Sunghak Lee
Effect of material damage on forming limits of voided anisotropic sheet metals
Young-Suk Kim, Sung-Yeun Won, Kyoung-Hoan Na
Mechanical measurements of passive film fracture on an austenitic stainless steel
D. Rodriguez-Marek, D. F. Bahr, M. Pang
Effect of microstructure on hydrogen embrittlement of weld-simulated HSLA-80 and HSLA-100 steels
K. Banerjee, U. K. Chatterjee
Effect of temper rolling on texture formation in a low loss cold-rolled magnetic lamination steel
S. W. Cheong, E. J. Hilinski, A. D. Rollett
Grain growth in a low-loss cold-rolled motor-lamination steel
S. W. Cheong, E. J. Hilinski, A. D. Rollett
Properties of TiAl sheet pack-rolled at temperatures below 1000°C
M. R. Shagiev, G. A. Salishchev, O. N. Senkov, F. H. Froes
Recrystallization of a cold-rolled low-carbon steel by cold-plasma-discharge rapid annealing
Joëlle Stockemer, Pierre Vanden Brande, Pierre Vanden Brande
On the analysis of grain size in bulk nanocrystalline materials via x-ray diffraction
Z. Zhang, F. Zhou, E. J. Lavernia
Mechanical properties of 2014Al/SiC composites with oxidized SiC particles
Jong-Hoon Jeong, Youngman Kim, Jae-Chul Lee
Communications
Further discussion on the free growth behavior in the solidification of undercooled eutectic melts
Mingjun Li, Kazuhiko Kuribayashi, Kazuhiko Kuribayashi
Communications
Compressive failure of a unidirectional carbon-epoxy composite at high strain rates
S. Sivashanker, S. O. Osiyemi, Asim Bag