Relevance of SEM to Long-Term Mechanical Properties of Cemented Paste Backfill

This paper is an attempt to relate the microstructure to long-term mechanical properties of the cemented paste backfill produced from a hard rock mine tailing from North Queensland in Australia bound with flyash-based geopolymer (geopolymer), flyash-blended cement (FBC), and general purpose cement (GPC). A relatively high slump (260 mm) paste backfill mix with 74 wt% solids has been used to prepare cylindrical paste backfill samples with a diameter of 50 mm and a height of 100 mm. The uniaxial compressive strength tests were conducted on all samples after curing for 112 days to obtain their strength, failure strain and Young’s modulus. Fractured samples were examined under scanning electron microscope to understand the failure mechanisms at the microstructural scale. The results show that binders significantly affected the mechanical properties of paste backfills (ANOVA, p < 0.05). The paste backfill bound with geopolymer gave the lowest strength and Young’s modulus, while the paste backfills bounded with FBC and GPC showed comparable higher strength and modulus values. This was attributed to the relatively well-packed paste backfills with less cracks and smaller pore sizes in these paste backfills bound with FBC and GPC binders. In particular, needle-shaped particles, which were originally identified in GPC, highly influenced the mechanical property of paste backfills. These results indicate that fly ash can be used to partially replace the cement as a binder for paste backfills to achieve economic and environmental benefits.