Preparation, characterization and photocatalytic activity of TiO₂ / Methylcellulose nanocomposite films derived from nanopowder TiO₂ and modified sol–gel titania

TiO₂—methylcellulose (MC) nanocomposite films processed by the sol-gel technique were studied for phocatalytic applications. Precalcined TiO₂ nanopowder was mixed with a sol and heat treated. The sol suspension was prepared by first adding titanium tetra isopropoxide (Ti(OPr)₄ or TTP) to a mixture of ethanol and HCl (molar ratio TTP:HCl:EtOH:H₂O = 1:1.1:10:10) and then adding a 2 wt.% solution of methylcellulose (MC). The TiO₂ nanopowder was dispersed in the sol and the mixture was deposited on a microscope glass slide by spin coating. Problems of film inhomogeneity and defects which caused peeling and cracking during calcinations, because of film shrinkage, were overcome by using MC as a dispersant. Effect of MC on the structure evaluation, crystallization behavior and mechanical integrity with thermal treatment up to 500 °C are followed by SEM, XRD and scratch test. XRD Scanning electron microscopy (SEM) showed that the composite films with MC have much rougher surface than films made without MC. Composite films heat treated at approximately 500 °C have the greatest hardness values. For the composite thick film, the minimum load which caused the complete coating removal was 200 g/mm², an indication of a strong bond to the substrate. Photocatalytic activities of the composite film were evaluated through the degradation of a model pollutant, the textile dye, Light Yellow X6G (C.I. Reactive Yellow 2) and were compared with the activity of (i) a similar composite film without MC, and (ii) a TiO₂ nanopowder. The good mechanical integrity make this composite film an interesting candidate for practical catalytic applications.