Full-Field Surface 3D Shape and Displacement Measurements Using an Unfocused Plenoptic Camera

Full-field surface 3D shape and displacement measurements using a single commercial unfocused plenoptic camera (Lytro Illum) are reported in this work. Before measurements, the unfocused plenoptic camera is calibrated with two consecutive steps, including lateral calibration and depth calibration. Each raw image of a checkerboard pattern recorded by Lytro Illum is first extracted to an array of sub-aperture images (SAIs), and the center sub-aperture images (CSAIs) at diverse poses are used for lateral calibration to determine intrinsic and extrinsic parameters. The parallax maps between the CSAI and the remaining SAIs at each pose are then determined for depth parameters estimation using depth calibration. Furthermore, a newly developed physical-based depth distortion model is established to correct the serious distortion of the depth field. To realize shape and deformation measurements, the raw images of a test sample with speckle patterns premade on its surface are captured by Lytro Illum and extracted to arrays of SAIs. The parallax maps between the CSAI and the target SAIs are obtained using subset-based digital image correlation. Based on the pre-computed intrinsic and depth parameters and the disparity map, the full-field surface 3D shape and displacement of a test object are finally determined. The effectiveness and accuracy of the proposed approach are evaluated by a set of experiments involving the shape reconstruction of a cylinder, in-plane and out-of-plane displacement measurements of a flat plate and 3D full-field displacement measurements of a cantilever beam. The preliminary results indicate that the proposed method is expected to become a novel approach for full-field surface 3D shape and displacement measurements.