Reflectance spectroscopy and remote sensing data for finding sulfide-bearing alteration zones and mapping geology in Gilgit-Baltistan, Pakistan

Gilgit-Baltistan region is covering the northern most part of Pakistan where the rocks of the Kohistan-Ladakh island arc and Karakoram plate are exposed. The area has greater potential for precious and base metals deposits which are needed to be explored through spectroscopy and remote sensing techniques. Minerals and rocks can nowadays be identified through the measurement of their absorption and reflectance features by spectroscopic analysis. Spectral reflectance analysis is also very important in selecting the appropriate spectral bands for remote-sensing data analysis of unknown or inaccessible areas. In this study, reflectance spectra in the spectral range of 0.35–2.5 μm of different types of unaltered and altered rocks found in the Machulu and Astor areas of northern Pakistan were obtained using an ASD spectroradiometer. The fresh rock samples showed low spectral reflectance as compared to the altered rock samples. The minerals jarosite, goethite, and hematite showed depth of absorption minima in the range of 0.4–1.15 μm due to the presence of iron (Fe), while jarosite and limonite showed absorption depth at 2.2 μm due to the presence of hydroxyl ions (OH^¯). The clay minerals montmorillonite and illite showed absorption depth at 1.93 and 2.1 μm, respectively. Muscovite showed depth of absorption minima at 1.4 and 1.9 μm in some samples. Calcite showed deep absorption minima at 2.32 μm, while anorthite showed absorption features at 1.4, 1.9, 2.24, and 2.33 μm. Olivine showed a slight depressed absorption feature at 1.07 μm. The copper-bearing phases malachite, chrysocolla, and azurite showed, respectively, a broad absorption feature in the range of 0.6–0.9 μm, a small absorption at 1.4 μm, and a deep absorption at 1.93 μm. The unmineralized samples exhibited high reflectance in the wavelength ranges of 0.6–0.8, 1.6–1.9, 2.0–2.3, 2.1–2.25, and 2.4–2.5 μm, respectively, while the mineralized samples showed reflectance bands in the wavelength ranges of 0.4–0.6, 1.3–1.8, and 2.1–2.2 μm. On this basis, the band ratio combinations 7/5–4/3–6/3 and 7/5–6/3–4/3 of Landsat 8 and 4/7–4/3–2/1 for ASTER data were found to be very effective in the lithological differentiation of major rock units.