Ausgabe 5/2001
Inhalt (16 Artikel)
Effects of surface preparation on pitting resistance, residual stress, and stress corrosion cracking in austenitic stainless steels
A. Ben Rhouma, H. Sidhom, C. Braham, J. Lédion, M. E. Fitzpatrick
Microstructural modification in a laser-treated 2.25Cr-1Mo steel
R. V. Subba Rao, P. Parameswaran, R. K. Dayal
The effect of graphite particles addition on the surface finish of machined Al-4 Wt.% Mg alloys
Mohammed T. Hayajneh, Adel Mahammod Hassan, Mohammad Abdul-Hameed Al-Omari
Effects of cooling time and alloying elements on the microstructure of the gleeble-simulated heat-affected zone of 22% Cr duplex stainless steels
Rong-Iuan Hsieh, Horng-Yih Liou, Yeong-Tsuen Pan
Effect of oxide additives and particle size on stabilization of treated commercial zirconia
Maham Yasmeen, Syed Asif Ansar, Amir Azam Khan, Thierry Joyeux, Jean Claude Labbe
Low cost corrosion damage mitigation and improved fatigue performance of low plasticity burnished 7075-T6
Paul S. Prevéy, John Cammett
Structure-property correlation of two Cu-bearing high-strength low-alloy steels
T. B. Bini, D. Kanchanamala, K. J. L. Iyer, S. Sundaresan, V. M. Radhakrishnan
Kinetics of strain aging in bake hardening ultra low carbon steel—a comparison with low carbon steel
A. K. De, B. C. De Cooman, S. Vandeputte
Fracture toughness properties of high-strength martensitic steel within a wide hardness range
N. M. Abd-Allah, M. S. El-Fadaly, M. M. Megahed, A. M. Eleiche
Grinding-induced residual stress estimation by indentation-fracture method in ground silicon nitrides
Toshihiko Hoshide, Junko Abe
Evaluation of an Al-Zn-Mg-Li alloy/potential candidate as Al-sacrificial anode
S. Valdez, B. Mena, J. A. Juarez-Islas, J. Genesca
Corrosion behavior of powder metallurgy Y2O3 dispersed iron-and nickel-base superalloys
M. Debata, G. S. Upadhyaya
Determination of the toughness of in-service steam turbine disks using small punch testing
J. Foulds, R. Viswanathan