nach oben

Electrical Engineering

Erschienen in:

01.12.2015 | Original Paper

Multi-tank resonant topologies as key design factors for reliability improvement of power converter for power energy applications

verfasst von: Michal Frivaldsky, Branislav Dobrucky, Michal Prazenica, Juraj Koscelnik

Erschienen in: Electrical Engineering | Ausgabe 4/2015

Einloggen

Aktivieren Sie unsere intelligente Suche, um passende Fachinhalte oder Patente zu finden.

search-config

KI-gestützte Suche

Aus

Abstract

To improve electrical properties of power converters suited for power energy systems, the paper deals with investigation of novel multi-tank resonant topologies. First, standard LLC converter is analyzed, as well as mathematical model during operation intervals is developed. After it, modifications of LLC converter for better dynamic behavior during start-up and short-circuit operation are described, whereby both operation modes have been verified and compared with standard solution. Next, modifications of LLC converter for electric drive applications were made. The main criterion was achievement of low value of THD of output variables (voltage and current). Based on analysis, physical model was constructed, whereby key results are experimentally supported at the end of the paper. Each design is confirmed with precise measurements. Each modification of standard LLC converter is mathematically supported to understand basic design of multi-tank resonant converters for modern industrial applications.

Vorheriger Artikel Estimating stray current interference from DC traction lines on buried pipelines by means of a Monte Carlo algorithm

Nächster Artikel A multi-level hierarchical communication network architecture for distributed generators

Sie haben noch keine Lizenz? Dann Informieren Sie sich jetzt über unsere Produkte:

Springer Professional "Wirtschaft+Technik"

Online-Abonnement

Mit Springer Professional "Wirtschaft+Technik" erhalten Sie Zugriff auf:

über 102.000 Bücher
über 537 Zeitschriften

aus folgenden Fachgebieten:

Automobil + Motoren
Bauwesen + Immobilien
Business IT + Informatik
Elektrotechnik + Elektronik
Energie + Nachhaltigkeit
Finance + Banking
Management + Führung
Marketing + Vertrieb
Maschinenbau + Werkstoffe
Versicherung + Risiko

Jetzt Wissensvorsprung sichern!

Jetzt informieren

Springer Professional "Technik"

Online-Abonnement

Mit Springer Professional "Technik" erhalten Sie Zugriff auf:

über 67.000 Bücher
über 390 Zeitschriften

aus folgenden Fachgebieten:

Automobil + Motoren
Bauwesen + Immobilien
Business IT + Informatik
Elektrotechnik + Elektronik
Energie + Nachhaltigkeit
Maschinenbau + Werkstoffe

Jetzt Wissensvorsprung sichern!

Jetzt informieren

Springer Professional "Wirtschaft"

Online-Abonnement

Mit Springer Professional "Wirtschaft" erhalten Sie Zugriff auf:

über 67.000 Bücher
über 340 Zeitschriften

aus folgenden Fachgebieten:

Bauwesen + Immobilien
Business IT + Informatik
Finance + Banking
Management + Führung
Marketing + Vertrieb
Versicherung + Risiko

Jetzt Wissensvorsprung sichern!

Jetzt informieren

Jovanovic MM (2006) Technology drivers and trends in power supplies for computer/telecom. APEC, Plenary session presentation

Heath CC (1991) The market for distributed power systems. In: Proc of the IEEE APEC ’91, 10–15 March 1991, pp 225–229

Tabisz WA, Jovanovic MM, Lee FC (1992) Present and future of distributed power systems. In: Proceedings of the IEEE APEC ’92, pp 11–18

http://www.energystar.gov/. Accessed Mar 2014

http://www.80plus.org/. Accessed Mar 2014

http://www.climatesaverscomputing.org/. Accessed Mar 2014

http://www.blauer-engel.de/en/. Accessed Mar 2014

Lee FC, Barbosa P, Xu P, Zhang J, Yang B, Canales F (2001) Topologies and design considerations for distributed power system applications. Proc IEEE 89(6):939–950CrossRef

Yang B (2003) Topology investigation for front end DC–DC power conversion for distributed power system. Ph.D dissertation

10.

Lee FC, Barbosa P, Xu P, Zhang J, Yang B, Canales F (2001) Topologies and design considerations for distributed power system applications. Proce IEEE 89(6):939–950CrossRef

11.

Lee KB, Blaabjerg F (2006) Improved direct torque control for sensorless matrix converter drives with constant switching frequency and torque ripple reduction. Int J Control Autom Syst 4(1):113–123

12.

Nguyen-Quang N, Stone DA, Bingham CM, Foster MP (2007) Comparison of single-phase matrix converter and H-bridge converter for radio frequency induction heating. In: European conference on power electronics and applications. IEEE, September 2007, pp 1–9

13.

Bala S, Venkataramanan G (2006) Matrix converter BLDC drive using reverse-blocking IGBTs. In: Twenty-first annual IEEE APEC ’06—applied power electronics conference and exposition, March 2006, pp 660–666

14.

Bernet S, Bernet K, Lipo TA (1996) The auxiliary resonant commutated pole matrix converter—a new topology for high power applications. In: Thirty-first IAS annual meeting, IAS ’96., conference record of the 1996 IEEE, industry applications conference, October 1996, vol, pp 1242–1249

15.

Almazan F, Lucia O, Acero J, Burdio JM, Carretero C (2011) A new multiple-output resonant matrix converter topology applied to domestic induction heating, pp 1–12

16.

Ecklebe A, Lindemann A (2007) Bi-directional switch commutationfor a resonant matrix converter supplying a contactless energy transmission system. In: Power conversion conference—Nagoya, 2007. PCC ’07, April 2007, pp 792–799

17.

Lucia O, Almazan F, Acero J, Burdio JM, Carretero C (2011) Multiple-output resonant matrix converter for multiple-inductive-load systems. In: 2011 twenty-sixth annual applied power electronics conference and exposition (APEC), IEEE, March 2011, pp 1338–1343

18.

Sangshin K, Toliya HA (2006) Direct AC/AC converters with 2 Legs and 3 Legsf or two-phase systems. In: 37th IEEE power electronics specialists conference, 2006. PESC’,06, June 2006, pp 1–5

19.

Kolar JW, Schafmeister F, Round SD, Ertl H (2007) Novel three-phase AC–AC sparse matrix converters. IEEE Trans Power Electron 22(5):1649–1661CrossRef

20.

Kolar JW, Friedli T, Rodriguez J, Wheeler PW (2011) Review of three-phase PWM AC–AC converter topologies. IEEE Trans Indus Electron 58(11):4988–5006CrossRef

21.

Szcześniak P (2013) Three-phase AC–AC power converters based on matrix converter topology matrix-reactance frequency converters concept, vol XII. Springer, London, p 174

22.

Vorobyov M (2011) Overview of single phase matrix converter application, pp 201–207

23.

Bhat AKS (1990) Analysis and design of LCL-type series resonant converter. In: Proc of the IEEE INTELEC, pp 172–178

24.

Yang B, Lee FC, Zhang AJ, Huang G (2002) LLC resonant converter for front end DC–DC conversion. Proc IEEE APEC 2:1108–1112

25.

Fiel A, Wu T (2001) MOSFET failure modes in the zero-voltage-switched fullbridge switching mode power supply applications. In: Applied power electronics conference and exposition, 2001. APEC 2001. Sixteenth Annual IEEE, pp 1247–1252

26.

Frivaldský M, Drgoňa P, Špánik P Experimental analysis and optimization of key parameters of ZVS mode and its application in the proposed LLC converter designed for distributed power system application. In: Electrical power and energy systems, vol 47, pp 448–456. ISSN 0142–0615

27.

Xie X, Zhang J, Zhao C, Zhao Z, Qian Z (2007) Analysis and optimization of LLC resonant converter with a novel over-current protection circuit. IEEE Trans Power Electron 22:435–443CrossRef

28.

Youssef M (2010) Analysis and design of LCC resonant inverter for the tranportation systems applications. In: Applied power electronics conference and exposition (APEC), 2010 Twenty-fifth annual IEEE, 21–25 Feb. ISBN 978-1-4244-4783-1

29.

Dianbo Fu (2008) Novel multi-element resonant converters for front-end DC/DC converters. In: Power electronics specialists conference, 2008. PESC 2008. IEEE, 15–19 June, ISBN 978-1-4244-1668-4

30.

Burdio JM, Canales F, Barbosa PM, Lee FC (2001) Comparison study of fixed-frequency control strategies for ZVS DC–DC series resonant converters. Proc IEEE PESC 1:427–432

31.

Daocheng H (2011) A novel integrated multi-elements resonant converter. In: Energy conversion congress and exposition (ECCE), 2011 IEEE, 17–22 Sept. ISBN 978-1-4577-0542-7

32.

Frivaldský M, Drgoňa P, Špánik P (2010) Hard switching process optimization for selected transistor suited for high power and high frequency operation. J Energy Power Eng 4(12). ISSN 1934–8975

33.

Špánik P, Frivaldský M, Drgoňa P, Kandráč J (2010) Efficiency increase of switched mode power supply trough optimization of transistor’s commutation mode. In: Electronics and electrical engineering (Elektronikairelektrotechnika). ISSN 1392–1215. No. 9 (105), s. 49–52

34.

Ang YA, Bingham CM, Foster MP, Stone DA, Howe D (2005) Design oriented analysis of fourth-order LCLC converters with capacitive output filter. IEE Electr Power Appl Proc 15(22):310–322

35.

Yuan B, Yang X, Li D (2007) A high efficiency current fed multi-resonant converter for high step-up power conversion in renewable energy harvesting. In: Modelling, identification, and control: proceedings of the 26th IASTED international conference, Feb 12–14, pp 440–445. Acta Press, Innsbruck, Austria, 2007. ISBN 978-0-88986-633-1

36.

Ang Y, Bingham CM, Foster MP, Stone DA (2007) Analysis and control of dual-output LCLC resonant converters, and the impact of leakage inductance. In: 7th International conference on power electronics and drive dystems, 2007. PEDS ’07, 27–30 Nov 2007, vol 23, pp 145–150

37.

Shafiei N, Pahlevaninezhad M, Farzanehfard H, Motahari SR (2011) Analysis and implementation of a fixed-frequency LCLC resonant converter with capacitive output filter. IEEE Trans Indus Electron 58(10):4773–4782CrossRef

38.

Jensen S, Corradini L, Rodriguez M, Maksimovic D (2011) Modeling and digital control of LCLC resonant inverter with varying load. In: Energy conversion congress and exposition (ECCE), 17–22 Sept, 2011 IEEE, vol 1, pp 3823–3829

Titel: Multi-tank resonant topologies as key design factors for reliability improvement of power converter for power energy applications
verfasst von: Michal Frivaldsky
Branislav Dobrucky
Michal Prazenica
Juraj Koscelnik
Publikationsdatum: 01.12.2015
Verlag: Springer Berlin Heidelberg
Erschienen in: Electrical Engineering / Ausgabe 4/2015
Print ISSN: 0948-7921
Elektronische ISSN: 1432-0487
DOI: https://doi.org/10.1007/s00202-015-0336-3

Springer Professional

Abstract

Bitte loggen Sie sich ein, um Zugang zu Ihrer Lizenz zu erhalten.

Sie haben noch keine Lizenz? Dann Informieren Sie sich jetzt über unsere Produkte:

Springer Professional "Wirtschaft+Technik"

Springer Professional "Technik"

Springer Professional "Wirtschaft"

Weitere Artikel der Ausgabe 4/2015

BFA optimization for voltage and frequency control of a stand-alone wind generation unit

Analytical and FEM approach to reduce the cogging torque in in-wheel motors

Detection of rotor fault in three-phase induction motor in case of low-frequency load oscillation

Estimating stray current interference from DC traction lines on buried pipelines by means of a Monte Carlo algorithm

Wind turbine gearbox fault diagnosis based on symmetrical components and frequency domain

Numerical analysis of local hot-spot temperatures in transformer windings by using alternative dielectric fluids