Ausgabe 9/1998
Inhalt (21 Artikel)
Fabrication of bulk ultrafine-grained materials through intense plastic straining
Patrick B. Berbon, Terence G. Langdon, Nikolai K. Tsenev, Ruslan Z. Valiev, Minoru Furukawa, Zenji Horita, Minoru Nemoto
Microstructural characteristics of ultrafine-grained aluminum produced using equal-channel angular pressing
Yoshinori Iwahashi, Minoru Furukawa, Zenji Horita, Minoru Nemoto, Terence G. Langdon
Microstructures and properties of nanocomposites obtained through SPTS consolidation of powders
I. V. Alexandrov, R. K. Islamgaliev, R. Z. Valiev, Y. T. Zhu, T. C. Lowe
Mechanical behavior of a bulk nanostructured iron alloy
J. E. Carsley, A. Fisher, W. W. Milligan, E. C. Aifantis
Effect of B on the microstructure and mechanical properties of mechanically milled TiAl alloys
Sang H. Kim, Nack J. Kim, H. H. Chung, Sung G. Pyo, S. J. Hwang
Static recrystallization kinetics with homogeneous and heterogeneous nucleation using a cellular automata model
R. L. Goetz, V. Seetharaman
Analysis of ridging in aluminum auto body sheet metal
A. J. Beaudoin, J. D. Bryant, David A. Korzekwa
Heterogeneous microstructures and microtextures in cube-oriented al crystals after channel die compression
Qing Liu, Niels Hansen, Claire Maurice, Julian Driver
An investigation of the fracture and fatigue crack growth behavior of forged damage-tolerant niobium aluminide intermetallics
F. Ye, C. MerCer, W. O. Soboyejo
Microstructural and compositional transients during accelerated directional solidification of Al-4.5 wt pct Cu
Rong-Jiunn Su, Ruel A. Overfelt, Wartan A. Jemian
Enhancement of the mechanical properties of a low-carbon, low-silicon steel by formation of a multiphased microstructure containing retained Austenite
P. Jacques, F. Delannay, X. Cornet, Ph. Harlet, J. Ladriere
Transmission electron microscope specimen preparation of Zn powders using the focused ion beam lift-out technique
B. I. Prenitzer, L. A. Giannuzzi, K. Newman, S. R. Brown, R. B. Irwin, F. A. Stevie, T. L. Shofner
Investigation of thermomechanical behavior of a work roll and of roll life in hot strip rolling
C. G. Sun, S. M. Hwang, C. S. Yun, J. S. Chung
A novel way of amorphous phase formation during mechanical alloying of copper and cadmium powders
D. L. Zhang, T. B. Massalski
Optimization of the strength-fracture toughness relation in particulate-reinforced aluminum composites via control of the matrix microstructure
I. Dutta, T. R. McNelley, R. Nagarajan, F. N. Quiles
Discussion of “Effect of dendrite arm coarsening on microsegregation”
T. Kraft, Y. A. Chang