The influence of magnetron sputtered silver and titanium coatings on the compaction and properties of surface modified PM Ti-48Al powders

Thin layers of silver and titanium were deposited onto commercial Ti–₄₈Al particles by magnetron sputtering prior to their consolidation by hot isostatic pressing and subsequent heat treatment. Based on picnometry and electron probe microanalysis results, average values of 1.5 and 2.5 at.%, respectively, were obtained for the silver and titanium contents in the coated particles. The surface modified Ti–₄₈Al particles exhibited improved sintering ability than the unmodified ones. The consolidated samples have duplex microstructures formed by γ-TiAl and γ-TiAl + α₂-Ti₃Al grains. Ag-rich nanoprecipitates were detected in the microstructure of the compacted Ti-₄₈Al + Ag sample. The coatings are no longer visible at the grains boundaries after a subsequent homogenization heat treatment at 1200°C. The highest values of hardness and Young’s modulus were obtained for the Ti–₄₈Al + Ag sample, associated with a higher density and a lower percentage of pores.