Effect of Anisotropy on the Manufacturing Process of Mg-Zn-Zr Alloy Connecting Rod

In this study, a new alloy material Mg-Zn-Zr (ZK60) was designed for the connecting rod. It was found that the blanks sampled along the vertical direction of an extruded bar crack during the roll forging process. The microstructure and precipitates of the extruded bar were observed and analyzed using optical microscope (OM), scanning electron microscope (SEM) and x-ray diffraction (XRD). The result showed that the Zn, Zr, and MnZn₂ precipitates were elongated along the extrusion direction. The mechanical anisotropy was investigated by testing the mechanical properties of the specimens sampling from different angles. Hot deformation behavior was further studied using the Gleeble 3500 thermal-mechanical simulator. The tensile and yield strengths were the highest along the extrusion direction, reaching 347 MPa and 301 MPa, respectively. The deformation resistance was also higher in the extrusion direction than that in the vertical direction. Fracture mechanisms of the sample from different directions were discussed. The ZK60 alloy was more susceptible to failure if the deformation direction was parallel to the bands of segregation area and precipitates.